Advertisement
The machine restarts with the gun released.
The machine does not suck in the detergent.
Turning on the burner switch the boiler does
not start.
WEEE REGULATIONS
Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment
(WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid
waste authority for recycling information.
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
© Jack Sealey Limited
Water leak from hose - gun connection
(except models with hose and gun supplied
ready connected).
Air in intake water.
Water leak from the gun.
Water leak from the pump.
Tank empty.
Lance handgrip is on high pressure setting (if
present).
Transparent suction pipe damaged or
disconnected.
No fuel
Fuel filter is clogged
Fuel pump is either blocked or burnt out
Damaged thermostat
Ignition spark insufficient or totally lacking
The space among the electrodes is not
correct
01284 703534
sales@sealey.co.uk
Original Language Version
Tighten the connection with 2 spanners.
Supply the machine with water correctly, refer
to section 5.
Contact an authorised service centre.
Contact an authorised service centre.
Fill the tank.
Move it to the low pressure setting by pulling
the lever towards the nozzle.
Reconnect the pipe. If the problem persists
contact an authorised service centre.
Check level in tank and check whether the
rigid suction pipe is clean
Replace the inline filter
Replace it
Replace it
Contact an authorised service centre
Contact an authorised service centre
www.sealey.co.uk
PW2500HW
Issue:1
12/01/21
Advertisement
