Advertisement
72FF-57E
81FF-57E
4− 4−
4−
4− 4− PIN AMPLITUDE
a) Internal pattern signal will be displayed.
b) When volume-up button is pressed, slide pincushion changes from
pincushion to barrel shape.
c) When volume-down button is pressed, slide pincushion changes from
pincushion to barrel shape.
d) Adjust the PIN AMPLITUDE to obtain condition as in (fig. 5).
5− 5−
5− 5− UPPER CORNER CORRECTION
5−
a) Internal pattern signal will be displayed.
b) When volume-up button is pressed, slide pincushion changes from
pincushion to barrel shape.
c) When volume-down button is pressed, slide pincushion changes from barrel
shape to pincushion.
d) Adjust the UPPER CORNER CORRECTION to obtain condition as in (fig.
6).
6− 6− LOWER CORNER CORRECTION
6− 6−
6−
a) Internal pattern signal will be displayed.
b) When volume-up button is pressed, slide pincushion changes from pincushion
to barrel shape.
c) When volume-down button is pressed, slide pincushion changes from barrel
shape to pincushion.
d) Adjust the LOWER CORNER CORRECTION to obtain condition as in (fig. 7).
7−
7− 7−
7− VERTICAL LINEARITY
7−
a) Internal pattern signal will be displayed.
b) When volume-up button is pressed, upper picture scanning decreases and
lower picture scanning increase.
c) When volume-down button is pressed, upper picture scanning increases and
lower picture scanning decrease.
d) Adjust the vertical symmetry to obtain symmetry scanning between upper and
lower picture (fig. 8).
8−
8− VERTICAL ANGLE
8− 8−
8−
a) Internal pattern signal will be displayed.
b) When volume-up button is pressed, vertical angle changes to right.
c) When volume-down button is pressed, vertical angle changes to left.
d) Adjust the VERTICAL ANGLE to obtain condition as in (fig. 9).
9− 9− VERTICAL BOW
9− 9−
9−
a) Internal pattern signal will be displayed.
b) When volume-up button is pressed, vertical bow changes to right.
c) When volume-down button is pressed, vertical bow changes to left.
d) Adjust the VERTICAL ANGLE to obtain condition as in (fig. 10).
10−
10−
10−
10−
10− VERTICAL AMPLITUDE
a) Internal pattern signal will be displayed.
b) When volume-up button is pressed, vertical size of picture increases.
c) When volume-down button is pressed, vertical size of picture decreases.
d) Adjust the vertical size to obtain overscan (fig. 11).
12−
12−
12−
12− S-CORRECTION
12−
a) Internal pattern signal will be displayed.
b) When volume-up button is pressed, upper and lower scanning decreases, and
center scanning increases.
c) When volume-down button is pressed, upper and lower scanning increases,
and center scanning decreases.
d) Adjust the S-CORRECTION to obtain a balance between upper, lower and
center (fig. 12).
6
Fig. 5
Fig. 6
Fig. 7
Fig. 8
Fig. 9
Fig. 10
Fig. 11
Fig. 12
Advertisement
