Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for CleanCraft KM 625
Summary of Contents for CleanCraft KM 625
- Page 1 Operating Instructions Sweeper KM 625 KM 825 KM 625 KM 825...
-
Page 2: Table Of Contents
Infringements will lead to claims for da- 16.1 Ordering spare parts........17 mages. 16.2 Spare parts drawings........18 16.2.1 Spare parts drawings KM 625 ....18 Subject to technical modifications and error. 16.2.2 Spare parts drawings KM 825 ....20 17 Electrical Circuit Diagrams ....22 17.1 Electrical circuit diagram KM 625 .... -
Page 3: Introduction
1.3 Limitation of liability You have made a good choice by purchasing the All information and notes in these operating instructions CLEANCRAFT Sweeper. were summarised while taking applicable standards and rules, the state-of-the-art technology and our longterm Read the operating manual thoroughly before com- knowledge and experiences into consideration. -
Page 4: Obligations Of The Operating Company
Safety 2.2 Obligations of the operating com- WARNING! pany This combination of symbol and signal words indi- The operating company is the person who operates the cates a potentially dangerous situation which may Sweeper for business or commercial reasons by herself, lead to death or severe injury if not avoided. -
Page 5: Qualification Of The Staff
Safety 2.3 Qualification of the staff Manufacturer Certain works may only be performed by specialist per- The different tasks described in this manual represent sonnel of the manufacturer. Other personnel is not au- different requirements to the qualification of the persons thorized to perform these works. -
Page 6: Safety Instructions Battery
Safety - Do not sweep up gel, liquid, flammable, explosive, in- - If the charger cable is damaged, it must be replaced candescent and harmful substances with the by the manufacturer, authorised dealer or equally sweeper. qualified personnel. - Do not sweep up liquids. - Do not use batteries that are not intended for use with the machine. -
Page 7: Intended Use
- Risk of fire if the battery is incorrectly connected. - Never clean floors with a height gradient greater than that indicated on the machine. - Do not use at altitudes above 2000m. Fig. 2: Type plate KM 625 KM Series | 1.02... -
Page 8: Scope Of Delivery
Scope of Delivery Scope of Delivery Transport, Packaging, Sto- rage Scope of delivery KM 625 and KM 825 - Battery 12V 42Ah AGM Transport "You can receive the safety data sheet from your spe- cialist dealer or by calling Tel: +49 (0)951/96555-0"... -
Page 9: Packaging
LED's for indicating the battery charge status. LED lights up green when the battery is charged, red when it is discharged and yellow when it is in reserve or recharge Fig. 3: Description KM 625 status. 1 Control panel 7 Button for manual activation of the filter shaker... -
Page 10: Assembling
Assembling 8 Button for switching off the automatically active in- take fan Intake fan: The intake fan is automatically switched on du- ring working operation. The switch is thus used when it is necessary to switch off the fan during machine operation. unlocking Assembling Unpack the machine carefully and avoid movements that... -
Page 11: Commissioning
Commissioning 11.1 Operating the charger Step 8: Remove the top cover of the sweeper to access the battery. Step 9: Connect the two cables with each other. Make ATTENTION! sure the cables are connected correctly . (Red to Be careful not to switch on the sweeper until the bat- Red and Black to Black) tery is fully charged. -
Page 12: Operation
Operation 12 Operation 13 Care, Maintenance and Repair 13.1Care by cleaning ATTENTION! The sweeper must always be kept in a clean condition. The machine must only be used by authorised per- sonnel. Do not leave the machine unattended when it is switched on. -
Page 13: Clean Pre-Filter
Care, Maintenance and Repair Manual cleaning of the main filter The filter should be cleaned every 20 working hours. If the filter shaker alone is not enough, the filter can be cleaned manually. Before carrying out any work on the machine, make sure that it is switched off and that all functions are deactivated. -
Page 14: Maintenance And Service/Repair
Care, Maintenance and Repair 13.2 Maintenance and Service/Repair 13.2.1 Replacing the sweeping brush Step 1: Switch off the machine. ATTENTION! Step 2: Lift the machine at the front. Maintenance and repair work must always be carried Step 3: Press in the two tabs on the sweeping brush and out by qualified personnel;... -
Page 15: Replacing The Main Sweeper Roller
Disposal, Recycling of old Equipment 14 Disposal, Recycling of old 13.2.2 Replacing the main sweeper roller Equipment Step 1: Switch off the machine. Step 2: Tilt the machine backwards until the handle tou- In your own interests and in the interest of the environ- ches the ground. -
Page 16: Troubleshooting
Just for refe- rence, the battery is If you cannot fix the problems with your sweeper by being charged. yourself, please contact your local Cleancraft dealer. Empty battery All machine functi- Please write down the following information regarding ons are interrupted. -
Page 17: Spare Parts
Spare Parts 16 Spare Parts Example The battery for the KM 625 sweeper must be ordered. DANGER! The battery has the number 39 in spare parts drawing 1. Risk of injury due to incorrect spare parts! When ordering spare parts, send a copy of the spare... -
Page 18: Spare Parts Drawings
The following drawings should help in case of service to identify necessary spare parts. To order, send a copy of the parts drawing with the parts marked to your authorized dealer. 16.2.1 Spare parts drawings KM 625 Spare parts drawing 1 Fig. 16: Spare parts drawing 1 KM 625 KM Series | 1.02... - Page 19 Spare Parts Spare parts drawing 2 Fig. 17: Spare parts drawing 2 KM 625 KM Series | 1.02...
-
Page 20: Spare Parts Drawings Km 825
Spare Parts 16.2.2 Spare parts drawings KM 825 Spare parts drawing 1 Fig. 18: Spare parts drawing 1 KM 825 KM Series | 1.02... - Page 21 Spare Parts Spare parts drawing 2 Fig. 19: Spare parts drawing 2 KM 825 KM Series | 1.02...
-
Page 22: Electrical Circuit Diagrams
Electrical Circuit Diagrams 17 Electrical Circuit Diagrams 17.1Electrical circuit diagram KM 625 Fig. 20: Electrical circuit diagram KM 625 KM Series | 1.02... -
Page 23: Electrical Circuit Diagram Km 825
Electrical Circuit Diagrams 17.2 Electrical circuit diagram KM 825 Fig. 21: Electrical circuit diagram KM 825 KM Series | 1.02... -
Page 24: Ec - Declaration Of Conformity
According to Machinery Directive 2006/42/EC Annex II 1.A Manufacturer/Distributor: Stürmer Maschinen GmbH Dr.-Robert-Pfleger-Str. 26 D-96103 Hallstadt hereby declares that the following product Product group: Cleancraft® Cleaning technology Type of machine: Sweeper Designation of machine *: KM 625 Item number *: 7302162... - Page 25 Notes 19 Notes KM Series | 1.02...
- Page 26 www.cleancraft.de...
Need help?
Do you have a question about the KM 625 and is the answer not in the manual?
Questions and answers