Related Manuals for Perenio IONIC SHIELD PEWOW01COV
Summary of Contents for Perenio IONIC SHIELD PEWOW01COV
- Page 1 Installation and Operation Manual for the PERENIO IONIC SHIELD™ Cold Plasma Emitter (Model: PEWOW01COV, PEWOW01COVUK) December, 2021...
-
Page 3: Table Of Contents
Figure 4 – Scope of Supply ................22 Figure 5 – Examples of installation ..............23 Figure 6 – View of the sticker atop the capsule ..........24 © Perenio IoT spol s r.o. All rights reserved Document version: 1.0.8 Page 3 of 35... - Page 4 Table 2 – Basic technical specifications ............20 Table 3 – CoV Capsule ................27 Table 4 – Typical Errors and Troubleshooting Methods ........34 Document version: 1.0.8 © Perenio IoT spol s r.o. All rights reserved Page 4 of 35...
-
Page 5: Introduction
® and PERENIO IONIC SHIELD™ trademarks are licensed to Perenio IoT spol s r.o. (hereinafter referred to as the Perenio IoT). All other similar trademarks and names, as well as logos and other symbols are the property of their respective owners. -
Page 6: Disclaimer
While the Device is intended for prevention of infections caused by known coronaviruses by significant reduction of level of the viral load in the enclosed area of application, Perenio IoT and/or the manufacturer of the Device do not Document version: 1.0.8 ©... - Page 7 Perenio IoT and/or the manufacturer. Users understand and accept that the use of multiple Devices at once, as well as any attempt to compromise the capsule’s enclosure, in a closed space, may...
-
Page 8: Responsibility And Technical Support
Perenio IoT reserves the right to make corrections or changes to this Manual without prior notice to the users of the Device and shall not be responsible for any consequences which may arise from the use of an outdated version of the Manual,... -
Page 9: Conformance To Standards
Installation and Operation Manual for the PERENIO IONIC SHIELD™ Cold Plasma Emitter Conformance to Standards • Perenio IoT has been certified in accordance with EN ISO 9001 and EN ISO 14001 The Device is CE certified and complies with the... -
Page 10: Warnings And Restrictions
Indication on the need for the user to consult the Installation and Operation Manual for important information such as warnings and cautions The Device is for indoor installation only Document version: 1.0.8 © Perenio IoT spol s r.o. All rights reserved Page 10 of 35... - Page 11 Indication of the Device manufacturer Indication of the manufacturer's catalogue number (product article) of the Device. Same model is in products catalog of Perenio IoT so that it can be easily identified Indication of the temperature limits to which the Device can be safely...
- Page 12 Do not use cleaning agents or detergents to clean the Device, as well as gasoline, furniture polish, or rough brushes, because this may cause deterioration to the surface of the Device. Document version: 1.0.8 © Perenio IoT spol s r.o. All rights reserved Page 12 of 35...
- Page 13 4. It is forbidden to connect a USB-PD (Power Delivery quick charge technology) power adapter to the Device. 5. Perenio IoT and/or the manufacturer shall not be liable for any damages resulting from the use of the power adapter in a manner other than as outlined herein.
- Page 14 Device, is the dry eyes. Clinical trials evaluating the general safety and performance requirements of the Device will continue, and any updates will included Manual available downloading perenio.com/documents. Document version: 1.0.8 © Perenio IoT spol s r.o. All rights reserved Page 14 of 35...
- Page 15 The user may also report any serious incidents in relation to the Device to the competent authority of the Member State in which the user is established. © Perenio IoT spol s r.o. All rights reserved Document version: 1.0.8 Page 15 of 35...
-
Page 16: General Description And Specifications
PERENIO IONIC SHIELD™ Cold Plasma Emitter 1 General Description and Specifications 1.1 Device Purpose PERENIO IONIC SHIELD™ PEWOW01COV, PEWOW01COVUK is a Cold Plasma Emitter which consists of two major components: • CoV capsule with two trays filled with ionic substance based on salts of Mg, K, Au, Pt, Zn. -
Page 17: Figures And Tables Figure 1 - Exterior (Side View)
Installation and Operation Manual for the PERENIO IONIC SHIELD™ Cold Plasma Emitter – Exterior (Side view) Figure 1 – Exterior (Top view) Figure 2 © Perenio IoT spol s r.o. All rights reserved Document version: 1.0.8 Page 17 of 35... -
Page 18: Figure 3 - Buttons, Connectors And Indicators
Replaceable module with metal salt composition from which negative, positive and bipolar ions are emitted Mounting holes Holes in the Device casing used for mounting purposes Document version: 1.0.8 © Perenio IoT spol s r.o. All rights reserved Page 18 of 35... - Page 19 3 seconds after pressing the power button) Red-blue Blinking Battery malfunction (Please contact our Tech Support Department) The Device is switched off and disconnected from the mains socket © Perenio IoT spol s r.o. All rights reserved Document version: 1.0.8 Page 19 of 35...
-
Page 20: Technical Specification
Standby discharge time: up to 60 days Service life: 600 recharge cycles Power Adapter Type: USB-C (Power Delivery is not supported) Input voltage: 100VAC to 240VAC Document version: 1.0.8 © Perenio IoT spol s r.o. All rights reserved Page 20 of 35... - Page 21 Capsule: 12 months of operation Battery: 600 recharge cycles Shelf life of the capsule 7 years as from the date of manufacture Certificates CE, EAC, RoHS, UCKA © Perenio IoT spol s r.o. All rights reserved Document version: 1.0.8 Page 21 of 35...
-
Page 22: Device Package
Weights of the package are: • Net weight: 450g; • Gross weight: 560g. Document version: 1.0.8 © Perenio IoT spol s r.o. All rights reserved Page 22 of 35... -
Page 23: Installation And Setup
Device operation; • Ability to be at a distance of more than 25cm from the Device in operation; © Perenio IoT spol s r.o. All rights reserved Document version: 1.0.8 Page 23 of 35... -
Page 24: Preparation For Work
“CLOSED” position (See Figure 7-c). 7-a – pressing on top 7-b – “OPEN” position 7-c – “CLOSED” position Tightening the capsule Figure 7 – Document version: 1.0.8 © Perenio IoT spol s r.o. All rights reserved Page 24 of 35... -
Page 25: Operation Process
The average operating time of the Device depends on the size of the enclosed area of application (See Table 2 above). NOTE. Continuous operation of the Device is allowed. © Perenio IoT spol s r.o. All rights reserved Document version: 1.0.8 Page 25 of 35... -
Page 26: Removing And Replacing The Cov Capsule
“CLOSED” position (see Figure 8-d). 6. The Device is now ready for use. 8-a - Untightening the capsule 8-b – Removing the capsule Document version: 1.0.8 © Perenio IoT spol s r.o. All rights reserved Page 26 of 35... - Page 27 +40°C and forms a gel with the ionic substance which remains liquid in porous large crystal lattice of the polymer. © Perenio IoT spol s r.o. All rights reserved Document version: 1.0.8 Page 27 of 35...
- Page 28 Device. The shelf life of the CoV capsule shall be seven (7) years as from the date of manufacture. Document version: 1.0.8 © Perenio IoT spol s r.o. All rights reserved Page 28 of 35...
-
Page 29: Maintenance And Repair
If the capsule is worn out or damaged, it shall be replaced with a new one (not included in the scope of delivery). Never use a damaged capsule! © Perenio IoT spol s r.o. All rights reserved Document version: 1.0.8... -
Page 30: Warranty
The manufacturer shall guarantee that all materials, components and assemblies of Perenio ® devices are free from defects under normal operation within the warranty period. The limited warranty shall be applied to the first user of Perenio ® devices only and cannot be transferred to any subsequent users. - Page 31 Installation and Operation Manual for the PERENIO IONIC SHIELD™ Cold Plasma Emitter LIMITATION OF LIABILITY PERENIO IONIC SHIELD™ SHALL NOT BE SUBJECT TO a free warranty service in case of: • Any damage caused by force majeure, accidents, and willful or careless acts (omissions) of the user or third parties;...
-
Page 32: Storage, Transportation And Disposal Of Devices
(including supplied batteries (if any), components containing mercury, etc.). Document version: 1.0.8 © Perenio IoT spol s r.o. All rights reserved Page 32 of 35... -
Page 33: Other Information
Certificate of Conformity (LVD) #2101604701E/L21/48003 as of January 15, 2021; Certificates Certificate of Conformity (ECD) #2101604701E/L21/48004 as of January 15, 2021. Declarations EU declaration of conformity © Perenio IoT spol s r.o. All rights reserved Document version: 1.0.8 Page 33 of 35... -
Page 34: Troubleshooting
Power it on again. If the problem persists, please contact our Tech Support Department Malfunction of the Replace the capsule capsule Document version: 1.0.8 © Perenio IoT spol s r.o. All rights reserved Page 34 of 35... -
Page 35: Glossary
Degree of protection of the Device, indicating that the parts inside the case are protected from the penetration of objects and solid bodies larger than 2.5mm. No moisture protection © Perenio IoT spol s r.o. All rights reserved Document version: 1.0.8 Page 35 of 35...