1. Manuals
  2. Brands
  3. Martec Manuals
  4. Receiver
  5. MPLCDS
  6. Installation manual

Martec MPLCDS Installation Manual

Hide thumbs
1
2

Advertisement

Table of Contents

M P L C D S I n s t a l l a t i o n G u i d e

WARNING

Installation MUST carry out by a qualified and licensed electrician.

IMPORTANT REMINDER

1.
The supply to the remote control receiver should be connected through a mains switch, i.e.
existing wall switch.
2.
Disconnect from power at wall switch before working on remote control receiver or ceiling fan.
3.
Install receiver into the ceiling fan canopy of the fan to ensure proper protection.
4.
This unit is to be used for the control of ceiling fan and in a AC230/240V 50Hz power supply
only.
5.
Do not install in damp locations or immerse into water. (For indoor use only.)
6.
Do not pull on or cut leads shorter.
7.
Do not drop or bump the unit.
NB: The battery will weaken with age and should be replaced before leaking takes place as this will
damage the transmitter. Dispose of used battery properly, keep the battery out of reach of
children.

INSTALLATION INSTRUCTIONS

1.
Ceiling fan must be set at HIGH speed and light kit (If any) at ON position after installation.
2.
Once the connection has been made, the receiver inserts into the drop rod hanging bracket.
3.
Please make sure the antenna wire has been safely folded inside the canopy cover before final
assembly (DO NOT cut the antenna wire).
NB: Incorrect wire connection would damage the receiver.
RECEIVER INSTALLATION DIAGRAM
E: sales@martecltd.com.au | P: 02 8778 7500
www.martecaustralia.com.au
RECEIVER WIRING DIAGRAM

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MPLCDS and is the answer not in the manual?

Questions and answers

Related Manuals for Martec MPLCDS

Summary of Contents for Martec MPLCDS

  • Page 1 M P L C D S I n s t a l l a t i o n G u i d e WARNING Installation MUST carry out by a qualified and licensed electrician. IMPORTANT REMINDER The supply to the remote control receiver should be connected through a mains switch, i.e. existing wall switch.
  • Page 2 WARNING Installation MUST carry out by a qualified and licensed electrician. CODE SWITCH 1. . Codes are set by pushing dip switches up and down. It is imperative that the code used f both transmitter and receiver is exactly the same; otherwise remote controller will not work.

Table of Contents