GE JTP35DP Dimensions And Installation Information

Cutout width
JTP35DP
28-1/2'' MIN. 5
28-5/8'' MAX.
GE 30" Built-In Double Wall Oven
®
Dimensions and Installation Information (in inches)
A
B
KW Rating
240V
Conduit 6.9
(72"
208V 5.2
long)
Breaker Size
Cutout height
240V 30 Amps
51-13/16" MIN.
208V D
30 Amps
51-15/16" MAX.
A
Note: Cabinets installed adjacent to wall ovens
must have an adhesion spec of at least a 194°F
temperature rating. Electric wall ovens are 21
not approved for installation with a plug
and receptacle. They must be hard wired in
B
accordance with installation instructions.
Minimum cutout location
12" from the floor.
Door handle protrudes 3" from door face.
C
Cabinets and drawers on adjacent 45° and 90°
Cabinet
walls should be placed to avoid interference with width 30"
the handle.
Installation Information: Before installing,
consult installation instructions packed with
product for current dimensional data.
For answers to your Monogram, GE Profile
®
GE ® appliance questions, visit our website at
ge.com or call GE Answer Center
®
800.626.2000.
Cutout depth
23-1/2" MIN
Junction box
location
47" to
bottom of
junction box
Suitable
bracing
to support
runners
Cabinet
A – Overlap of oven over side of edges of cutout
B – Overlap of oven at top and bottom of cutout
Oven
C – Overall depth*
D – Overall height with trim
Overall height without trim
E – Overall width
*Depth including door handle is approximately 26-6/10" min. to
26-9/10" max.
or
™
service,
C L
2 x 4 or
equivalent
runners
21-5/8"
over centerline
of cabinet
(must support 325 lbs.)
30"
11/16"-3/4"
1"
21" minimum
Door Opening
23-1/2"
Allowance
53-3/8"
52-7/8"
29-3/4"
E
Conduit
48-1/2"
D
21
C
Cabinet
width 30"
MOST 30'' WALL CABINETS CAN BE USED WITH THIS UNIT.
THE OPENING BETWEEN THE INSIDE WALLS MUST BE AT LEAST 28-1/2'' WIDE.
All GE ranges are equipped with
an Anti-Tip device. The installation
of this device is an important,
required step in the installation
of the range.
Specification Created 5/09
Cutout width
28-1/2'' MIN. 5
28-5/8'' MAX.
Cutout depth
23-1/2" MIN
Junction box
location
A
B
47" to
bottom of
junction box
Cutout height
51-13/16" MIN.
51-15/16" MAX.
A
B
Minimum cutout location
12" from the floor.
Listed by
Underwriters
Laboratories
320143
Suitable
bracing
to support
runners
Cabinet
A – Overlap o
B – Overlap o
Oven
C – Overall de
D – Overall he
Overall he
E – Overall wi
*Depth includin
26-9/10" max.