Page 1
Phillips and flat screwdrivers (1) Leg stand with end caps Pliers (1) Steel Axle Ear protection, optional when hammering T-Nuts Figure 1 Lock Nut Aluminum Angle Trim Front Panel U-Brace T-Nut Support Angle Support Angle Leg Stand 8587700 0219S Rev 07/13...
Page 2
Assembly Important: Organize and identify all parts before beginning assembly. Read through all the instructions carefully. Tip: Check the tire pressure before assembly. Tires may lose pressure during shipping. Fill to 40 psi, if necessary. Tip: During assembly, you may find it helpful to use a nail or awl to clean out and line up the holes when placing bolts. If you have difficulty assembling your cart, please contact us at: info@gardeners.com or call 1-800-427-3363.
Page 3
Figure 4 Figure 3 Reverse View Support Angles Left Trim Front Right Bottom Bottom Panel Panel Right Left Trim back 5/8" Bolts U-Brace Front Figure 5 Figure 6 Wide side of Note the sloped sides trim faces out of the Aluminum Back Angles face the front of the cart...
Page 4
over please Figure 9 For a shorter handle, Step 10. Slide the Leg Stand over the assembled cart (Figure 8), aligning attach using two the holes in the Leg Stand with the holes in the Bottom and Side For a longer handle, attach 1-3/8"...