Table of Contents
Advertisement
11
FAQ and tips
Bad quality of reception
If no stations are found during a search or the message "No reception" is frequently displayed
when playing favourites, this can have several causes.
No external antenna is connected to the device:
■
–
The device is equipped with an internal antenna. This is sufficient when the reception is
of high quality. However, if the reception is bad, an external antenna is recommended,
such as a cable antenna. For the connection of an external antenna, see chapter 6.5.3
"Antenna" on page 23.
An external antenna is connected. The antenna mode is set on "Internal" in the device.
■
–
In this case the external antenna is not used by the device. Set the antenna mode of the
device on "External", see chapter 8.3.29 "Menu "Settings" - "Antenna"" on page 72.
No external antenna is connected. The internal antenna is being used. The antenna mode is
■
set on "External" in the device.
–
In this case the internal antenna is not used by the device. Set the antenna mode of the
device on "Internal", see chapter 8.3.29 "Menu "Settings" - "Antenna"" on page 72.
The external antenna is not ideally positioned.
■
–
The position of the external antenna can have a decisive effect on the quality of the
reception. The optimum position of the external antenna can only be determined locally
by means of testing. Keep changing the position of the external antenna until the
reception is of the right quality.
The device is at a location where there is no reception.
■
–
In this case an external antenna must be connected in an area that is located where
there is reception. For the connection of an external antenna, see chapter 6.5.3
"Antenna" on page 23.
The volume cannot be adjusted fully.
The maximum volume of the flush-mounted radio is adjusted down. During normal operation
■
the volume bar can then not be adjusted completely to the right.
–
For adjusting the maximum volume of the flush-mounted radio, see chapter 8.3.20
"Menu "Settings - "Maximum volume"" on page 63.
The alarm signal is low
The maximum volume of the flush-mounted radio is adjusted down. This also limits the the
■
volume of the alarm signal.
–
For adjusting the maximum volume of the flush-mounted radio, see chapter 8.3.20
"Menu "Settings - "Maximum volume"" on page 63.
Product manual 2CKA001473B5280
FAQ and tips
│95
Advertisement
Table of Contents
