Cleaning And Maintenance; Replacing The Uv Lamp - Hyundai HYUAP235 Instruction Manual

CLEANING AND MAINTENANCE

• Unplug the unit every time before cleaning
• Clean the dust collector and the metal pointers every one or two weeks or whenever there is
unusual sound durin operation. Otherwise the unit will discontinue due to excessive dust on the
collector. In general, a thorough cleaning will resume the unit to normal operation.
Cleaning the Metal Pointers
• After a certain period of time, the zigzag-shape metal pointers (ionizator) that release negative
ion will accumulate dust and dirt that will lower the efficiency of the appliance. Please clean the
metal pointers (ionizator) whenever the dust collector is cleaned.
• There are 2 cleaning lamellas with springs on the bottom part of the dust collector. If you clean
the ionizer with cleaning lamellas with springs, hold the upper button of the dust collector and
then repeat the process of removing and inserting the dust collector. When moving the dust
collector up and down, the cleaning lamellas clean the dust from the metal points.
Cleaning the Appliance
• The interior of the appliance also accumulate dust. Before putting the dust collector back after
cleaning, invert the entire unit for a few times to get rid of the accumulated dust.
• The exterior of the unit can be cleaned using mild detergent and then rinsing with clean water
and dry.
• Do not allow any liquid to enter the unit. Wait until the unit is completely dry before use.

REPLACING THE UV LAMP

• Lamps are effective for about 8,000 hours (about 12 months). Replace earlier if there is no „blue
glow" inside the housing.
• Press the release button A11 on the bottom part of the grid and then remove the lid by lifting it
and pulling it out (see picture 1 and 2). Turn the lamp softly and pull it out of its socket. Insert a
new lamp of the same type.
Cleaning the Dust Collection
• Remove the Dust Collector by holding the button at the
top. Use mild detergent to wipe off the dust from each of
the collection bars, then rinse with clean water and dry
thoroughly. Wait until the dust collector is completely dry
and then put it back into the unit. The dust collector is not
entirely inserted into the unit until a „click" sound is heard.
A - Pull out the dust collector
B - Wipe the collector with a piece of damp cloth
ENG - 26