Advertisement
Available languages
Available languages
Tools Required:
Phillips Head Screw driver
Electric drill and 10mm masonry bit for concrete/brick installation
Note: You need to put the bubble level system on the wall plate when you install the wall plate
and take it away after you finish installation.
Installation procedure:
Please make sure that all the components are in the package before the installation. And if any com-
ponents are missing, please stop the installation.
The following is the installation procedure:
Wood Stud Installation
For secure wood stud mounting, the wall
plate must be mounted to two studs at least
12" apart.
1. Use a high-quality electronic stud finder (commercially available)
to locate two adjacent studs and mark their locations with a pencil.
2. With the help of an assistant, and using the bubble level to ensure the wall plate is level, position
the wall plate against the wall in the desired mounting location.
positions of the small horizontal slots that are in alignment with the studs.
4. Next, pre-drill a 3mm hole in the wall stud at each marked location.
5. With the help of an assistant, position the wall plate against the wall and line up the mounting slots
with drilled holes.
6. For each location, insert a lag bolt and washer into the wall.
7. Tighten bolt with an open ended socket wrench by turning clockwise until tight.
CAUTION: Do not over-tighten bolts-doing so may cause unnecessary damage to the wall. Avoid
excessive torque.
CAUTION: Do not release the wall plate until it is properly mounted and secured to the wall.
Concrete/Brick Installation
1. Begin by placing the wall plate into position against the wall,
using the bubble level to keep it level.
2. Mark off six holes to be used for securing the mount and
place the wall plate aside.
3. Next, drill holes using an electric drill and 10mm masonry bit.
© by WilTec Wildanger Technik GmbH
http://www.wiltec.info
3. Mark
six
Seite 9
Advertisement
