WilTec 50540 Installation Manual page 10

4. Insert a concrete anchor into each hole.
5. If necessary, a hammer can be used to lightly tap each anchor into place so that they are flush
with the wall.
6. Once all of the anchors are in place, move the wall plate back into position.
7. Attach the nut onto the threaded shaft that is protruding from the wall.
8. Do not tighten until all nuts are in place.
Display Bracket Installation
Place your TV screen down on a soft, flat surface. Determine which screw is the correct length by
carefully inserting a straw, or toothpick, and mark how deep the mounting point is. If your display has a
curved back or a recessed thread mounting point, a spacer must be used.
1. Thread the right screws into the back of the TV, leaving about 5mm threads out.
2. Hooking your television into 4 holes of the TV bracket of the mount and get one people holding the
TV.
3. Thread the 4pcs screws tightly. Now the television has been installed.
Note:
a). Always hold your TV by enough people before you finish the installation.
b). Tighten all screws after install on the wall.
Display Adjustment
Tilt: You can adjust the tilt of your television by adjusting the screws with
column wrench located on the right-hand side and left-hand side of the
back of the plate.
1. First, turn the both screws counter-clockwise to loosen the plate.To tilt
the mount up, push the television on the upper to tilt the mount to the
position you want, then tighten both screws fully until it locked well.
2. To tilt the mount down, push the television on the downward to tilt the
mount to the position you want, then tighten both screws fully until it locked well.
Swivel:Grasp the upper and lower edges of the display, and then push or pull the display to the de-
sired swivel angle.
NOTE: The tension is preset at the factory .If you need to adjust the tension or lock the tilt an-
gle, loosen or tighten the tension nuts with the hex wrench.
Maintenance
Once you have mounted the bracket and the flat screen, check that they are sufficiently secure and
safe to use. You should repeat this check at regular intervals (at least once every three months).
© by WilTec Wildanger Technik GmbH
http://www.wiltec.info
10m
m
Seite 10