Speakman SA-1209 Instructions

INSTRUCTIONS FOR MODELS
SA-1209
For additional assistance or service please contact:
SPEAKMAN
® Company
400 Anchor Mill Road
New Castle, DE 19720
800-537-2107
customerservice@speakman.com
www.speakman.com
92-SA-1209-R2

TOOLS AND SUPPLIES

REQUIRED TOOLS & SUPPLIES:
Phillips
Flat Tip
Pencil
Screwdriver
Screwdriver
1/4 "Tile Drill Bit Rubber
Drill with 1/4" bit
(if mounting to tile) Hammer
or 1/2 "bit
HELPFUL TOOLS & SUPPLIES:
Measuring
Level
Tape

SAFETY TIPS

Be sure to wear eye protection.

MAINTENANCE

Your new Speakman Product is designed for years
of trouble-free performance. Keep it looking new by
cleaning it periodically with a soft cloth. Avoid
abrasive cleaners, steel wool, and harsh chemicals
as these will dull the finish and void your warranty.

WARRANTY

Additional warranty information can be found at:
www.speakman.com
1
Place Mounting Plates into desired position，
using a level to position them accordingly.
Mark mounting hole locations with a
pencil. Remove Mounting Plate from wall.
11 13
"
16
300mm
2
Option A -- Tile Wall Option A -- Tile Wall
Drill 1/4 in. holes in the previously
marked locations.
Ø1/4 in.
OR
2
Option B -- Option B -- Drywall with Steel Backer Plate. Drywall with Steel Backer Plate.
Drill 1/2 in. holes in the previously marked
locations.
Ø1/2 in.
3
Option A -- Tile Wall Option A -- Tile Wall
Insert Plastic Anchors into hole and use
rubber hammer to position Plastic Anchor
flush with wall surface.
OR
3
Option B -- Drywall with Steel Backer Plate. Option B -- Drywall with Steel Backer Plate.
Loosely assembly toggles through Mounting
Plate.
4 Option A -- Option A -- Tile Wall Tile Wall
Insert screws through Mounting Plate and
secure Mounting Plate to wall by tightening
screws.
OR