Advertisement
Figure 1
1. Access panel
6. Install the orifice onto the valve assembly as shown in
Figure 2 and hand tighten.
7. Install a 90-degree elbow fitting into the side of the
valve assembly with the open end pointing down
(Figure 2).
8. Install a 90-degree elbow fitting into the top of the
valve assembly with the open end pointing to the left
(Figure 2).
9. Install a 90-degree hydraulic fitting onto the top,
90-degree, elbow fitting with the open end pointing
down (Figure 2).
1
2
3
Figure 2
1. 90-degree hydraulic fitting
2. Orifice
10. Install the valve assembly to the valve bracket using
2 flange-head bolts (1/4 x 1-3/4 inches) and 2 flange
nuts (1/4 inch) (Figure 3).
4
G025099
3. Valve assembly
4. 90-degree elbow fitting
1. Flange nut (1/4 inch)
2. Valve bracket
11. Remove the existing hardware and set aside.
1. Existing hardware
12. Install the valve bracket to the machine frame behind
the vertical hoses using 2 flange-head bolts (M8 x
1-1/4 inch) and previously removed nuts as shown in
Figure 5.
2
Figure 3
3. Valve assembly
4. Flange-head bolt (1/4 x
1-3/4 inches)
1
Figure 4
g025107
Advertisement
