MASSEY FERGUSON 2650 Service Manual page 18

Protection of dismounted assemblies
If the tractor is going to stay disassembled for a long
time, organize the parts and protect them from dust
and humidity.
Keep new parts in their packaging until they are to
be used.
When putting the parts together, make sure that each
one is perfectly clean, with no plugged holes or
galleries.
The connectors, tubes and terminals of the fuel
injection pump and nozzles should be covered to
prevent any impurities from getting in.
You should do the same with the turbocharger, intake
and exhaust manifolds, etc.
Precision and certainty in adjustments
When putting the tractor back together, complete
every step for one part before moving on to the next
part. complete every step for one part before moving
on to the next part.
Make all of the adjustments that are recommended.
Check as many times as necessary to make sure
that everything is exactly right.
Adjustment shims
When removing bearing adjustment shims, keep
them together, and identify their location. Store them
clean and flat.
Electrical cables
Whenever you remove or disconnect a group of
wires or cables, identify the correct position of each
one with a tape label, to avoid incorrect reassembly.
HD Series 2600
Fig. 20
Fig. 21
Fig. 22
Fig. 23
Introduction
01
Adjustment
shims
01A01-13