Haier HWF10AN1 User Manual page 25

NZ AU
Problem
-
Excessive foam
detergent drawer.
Automatic adjust-
ment of washing
time.
Spinning fails.
washing result.
Washing powder
residues are on the
laundry.
Laundry has grey
patches.
Note: Foam formation
If too much foam is inspected during spin cycle, motor stops and drain pump will be ac-
tivated for 90 seconds. If that elimination of foam fails up to 3 times, programme ends
without spinning.
applicance, disconnect the power supply and contact the customer service.
10.4 In case of p o ower failure
The current programme and its setting will be saved.
When power supply is restored operation will be
resumed.
If a power failure cuts an operating wash programme
door opening is mechanically bloc
laundry water level should not be seen in the glassy
parts.
When the washing machine in a safe state (under the water level below the window along a certain
distance, barrel temperature below 55
machine operation.
10-Troubleshooting
Cause
• Detergent is not a appropriate.
•
Excessive use of detergent.
•
Washing programme duration will
be adjusted.
•
•
Degree of pollution does not agree
with selected programme
• Detergent quantitiy was not suffici-
•
Maximum load has been exceeded.
•
Laundry was unevenly distributed
in the drum.
•
Insoluble particles of detergent can
remain as white spots on the laun-
dry.
•
Caused by fats such as oils, creams
or ointments.
ked. To get out any
°C
Solution
• Check detergent recommen-
dations.
Reduce amount of detergent.
•
This is normal and doesn't
affect functionality.
• Check machine load and
laundry and run a spinning
programme again.
Select an other programme.
•
•
Choose the detergent acc. to
the degree of pollution and
according to manufacture
specifications.
• Reduce loading.
Loose the laundry.
•
•
Perform extra rinse.
Try to brush the points from the
•
dry laundry.
•
Choose an other detergent.
•
Pretreat the laundry with a
special cleaner.
10-1
10
, the inner barrel did not turn), may unlock the doors of the
25