Advertisement
Front Groove
Rectangular
Recess
• Lay the workshop on the floor, with the pegboard
facing up.
• Fit the rear tabs on each side of the tray into the
rectangular recesses on the inside of the legs.
• Hold the workshop legs together while pushing down
on the front of the tray. Make sure the front tabs on the
sides of the tray are aligned with the front grooves in
the workshop legs.
Note: You may want the help of another person to hold
the workshop legs together while sliding the tabs on the
sides of the tray into the grooves in the legs.
• Push the tray in firmly to secure it between the
workshop legs.
• Stand the workshop upright.
Vise
Vise Handle
• Insert the end of the vise handle through the hole in
the front of the vise.
Vise Handle
Front
of Tray
• Position the vise handle on a flat surface.
• Push firmly on the back of the vise to snap the vise
handle into the vise. Be careful to keep your fingers out
of the way!
Tray
Slots
• Insert the end of the vise handle through the opening in
the front of the tray.
• Fit the tabs on the back of the vise into the slots in the
tray.
• Push down firmly on the vise to attach it to the tray.
Toolholder
Right Leg
• Fit the pegs on the toolholder into the holes in the
outside of the right leg.
• Insert the tabs on the storage bucket into the grooves
in the outside of either leg.
• Slide the storage bucket down to secure it on the leg.
5
Tabs
Vise
Right Leg
Side View
Storage
Bucket
Vise Handle
Opening
Advertisement
