Advertisement
Quick Links
WOLF PUP 8.10
HEIGHT EXTENDER
PARTS
4X
height extender blocks
2X
1/4-20 x 1" pan head machine
screws
3X
1/4-20 x 1-3/4" Phillips truss
head machine screws
2X
1/4-20 x 1-1/4" Phillips truss
machine screws
1X
3/8" x 3-1/2" hex bolt
2X
1/4-20 x 2-1/2" Phillips truss
head machine screws
3X
1/4" flat washers
3X
1/4-20 lock nut
10X
extended treadle aid tie-ups
80X
extended tie-ups
2X
extended outside treadles*
8X
extended inside treadles*
*
These parts are included in the kit for adding a height
extender. If you ordered your loom with the height
extender, these parts will arrive attached to your loom.
NOTES:
■ If you received your height extender after you received your loom, you will
need to remove the treadles to replace them with the longer height extender
treadles.
■ Wolf loom legs are called out by where they cross each other. The legs that
touch the ground at the front of the loom are called "inside" legs because they
are covered by the "outside" legs when they cross at the loom center.
■ The brake is on the right side of loom. The beater is at the front of the loom.
■ The height extender legs are labelled:
RI = right inside, RO = right outside, LI = left inside, LO = left outside.
A
ssembly
For more information: schachtspindle.com
Schacht Spindle Company, 6101 Ben Place, Boulder, CO 80301
p. 303.442.3212 f. 303.447.9273
© 2019 Schacht Spindle Company, Inc.
I
nstructIons
REQUIRED TOOLS
#2 Phillips screwdriver
slotted (flat) screwdriver
two 9/16" (or adjustable) wrenches
FL3010
FL3086
flat washer
lock nut
Phillips truss head
machine screw
Phillips pan head
machine screw
carriage bolt
03.19
Advertisement
Related Manuals for Schacht WOLF PUP FL3010
Summary of Contents for Schacht WOLF PUP FL3010
- Page 1 ■ The height extender legs are labelled: RI = right inside, RO = right outside, LI = left inside, LO = left outside. For more information: schachtspindle.com Schacht Spindle Company, 6101 Ben Place, Boulder, CO 80301 p. 303.442.3212 f. 303.447.9273 © 2019 Schacht Spindle Company, Inc.
- Page 2 inside leg height extender blocks outside leg height extender blocks LO = left outside RO = right outside LI = left inside RI = right inside BOTTOM outer side inner side inner side outer side outer side inner side inner side outer side FIGURE 1: HEIGHT EXTENDER BLOCKS Unfold the loom on a flat surface.
- Page 3 the floor (Figure 4, page 4). Set aside the screwdriver. Repeat for the other height barrel nuts for Step 14. Spread the inside extender block. Set the rear leg brace legs apart and remove the treadle support. and attached height extender blocks at the rear of the loom.
- Page 4 hold the barrel nut in position. Secure the treadle support firmly. treadle Attach the height extender blocks support to the inside legs using 1/4-20 x 1-1/4" Phillips truss head machine screws, inserted from the inside of the leg through barrel nut the bottom hole (hole [C], Figure 4), then through the hole with the threaded insert on the height extender block (3rd hole...