Step 5 Pretest Check List; Step 6 Dishwasher Wet Test - GE GLC4400R Installation Instructions Manual

Installation Instructions
STEP 3 CONNECT THE UNICOUPLE TO THE
FAUCET
• Run garbage disposer,
if you have one, to
clean out the disposer
and thus allow water
to drain from the sink
through the disposer
and down the drain.
• Run hot water faucet to
purge cold water from
the hot water line. The hot water must be between 120°F and
150°F for best wash performance.
• Roll the dishwasher to a position just in front of the sink.
• Pull the unicouple and its hoses completely out from storage
compartment at rear of the dishwasher.
• Attach the unicouple to the faucet adapter following the three
steps below:
– Depress the locking collar at the top of the unicouple
– Place the unicouple completely over the faucet adapter
– Release the locking collar. The unicouple should now be
locked onto the faucet adapter.
• Turn on the hot water faucet and check for leaks. If leak is
detected, disconnect the unicouple, and refer to Step 4.
Note: The unicouple's small hose carries water from the
faucet to the dishwasher. The large hose carries water from
the dishwasher to the sink. Orient the faucet with unicouple
attached so water from the unicouple will run into the sink drain.
STEP 4 FAUCET ADAPTER LEAK
Skip this step if no unicouple leak was observed
If a unicouple leak was observed in Step 3, take whatever
actions are necessary to repair the leak. This may be as simple
as tightening the faucet adapter. Or, it may require the services
of a plumber if water is leaking from the interface between the
moveable faucet arm and the fixed part of the faucet fastened
to the sink.
Collar
Unicouple collar

STEP 5 PRETEST CHECK LIST

Review this list after connecting your dishwasher to avoid
charges for a service call that is not covered by your warranty.
Open door and remove all foam and paper packaging. Open door and remove all foam and paper packaging.
■
Locate the Owner's Manual. Locate the Owner's Manual.
■
Read the Owner's Manual to familiarize yourself with the Read the Owner's Manual to familiarize yourself with the
■
operation of the dishwasher.
Remove the protective film, if present, from the control Remove the protective film, if present, from the control
■
panel.
Add 2 quarts of water to the bottom of the dishwasher to Add 2 quarts of water to the bottom of the dishwasher to
■
lubricate the pump seal.

STEP 6 DISHWASHER WET TEST

• Plug power cord into outlet.
• Close and latch dishwasher door.
• Start dishwasher:
Timer Dial Models
– Press Normal pad
– Turn dial just enough to start dishwasher. Dial should point
to "Hot Start". Do not turn the dial too far. If you turn it too
far you will "by pass" the fi ll.
Electronic Models
– Press "Rinse Only"
– Press the start pad one time.
• Check to be sure that water enters the dishwasher. This could
take up to 4 minutes on dial models.
• If water does not enter the dishwasher
– Check to be sure that the water is turned on
– Lightly tap the fl ood fl oat cover to dislodge a stuck fl ood
fl oat.
– On dial models, make sure you did not turn the dial past the
fi rst fi ll. If this happened, unlatch the door and rotate the
dial to "Off". Re-latch door and turn the dial one click at a
time until the dishwasher starts.
– On electronic models, make sure the start pad was pressed
one time only.
Flood Float
Cover
3