Advertisement
Advertisement
Table of Contents
Related Manuals for Wesco WS8303U
Summary of Contents for Wesco WS8303U
- Page 1 WS8303U (CCS36WT) Cordless chainsaw...
- Page 3 13 14...
- Page 4 Fig.A1 Fig.A2 Fig.A4 Fig.A3 Fig.A5 Fig.B1 kink Fig.B2 Fig.C...
- Page 5 Fig.D Fig.E Fig.G Fig.F Pos.1 Pos.2 Hand guard Pos.1 Fig.H Fig.I Fig.J...
- Page 6 Fig.K Fig.L Injecting grease to lubricate Fig.N Fig.M...
-
Page 7: Product Safety
PRODUCT SAFETY modify the plug in any way. Do not use any adaptor plugs with earthed (grounded) power tools. WARNING: Some dust created by power sanding, Unmodified plugs and matching outlets will reduce risk sawing, grinding, drilling and other construction of electric shock. -
Page 8: General Chain Saw Safety Warnings
from moving parts. Loose clothes, jewellery or long hair another battery pack. b) Use power tools only with specifically designated can be caught in moving parts. g) If devices are provided for the connection of dust battery packs. Use of any other battery packs may extraction and collection facilities, ensure these are create a risk of injury and fire. - Page 9 wiring. Saw chains contacting a “live” wire may make serious personal injury. exposed metal parts of the chain saw “live” and could o) Recommendation that the first-time user should, as give the operator an electric shock. a minimum, practise cutting logs on a saw-horse or d) Wear safety glasses protection.
-
Page 10: Safety Warnings For Battery Pack
Recharge only with the charger specified by WESCO. Do not use any charger other than that specifically provided for use with the equipment. Retain the original product literature for future reference. - Page 11 SAVE THESE INSTRUCTIONS use the retreat path planned ( ). Be alert for overhead limbs falling and watch your footing. (See Figure 1.) Instructions concerning the proper techniques for basic Fig.1 Fig.3 felling, limbing, and cross-cutting: 1. Felling a tree When bucking and felling operations are being performed by two or more persons at the same time, the felling operations should be separated from the bucking...
- Page 12 Fig.1 Fig.3 SYMBOLS When the log is supported on one end, as illustrated in Figure 4, cut 1/3 the diameter from the underside (underbuck) (1). Then make the finished cut by To reduce the risk of injury, user must read overbucking (2) to meet the first cut.
-
Page 13: Component List
16. Bar pad 17. Bar tensioning plate 18. Bar and chain storage/ Transportation cover (sheath) 19. Battery pack release button (See Fig. F) TECHNICAL DATA Type WS8303U (CCS36WT) (83 - designation of machinery, representative of chain saw) Voltage 2*20V Max* Bar length 12”... - Page 14 A loose 2. Place the chainsaw on a solid, level surface. chain may jump out of guide bar groove. This may 3. Use only genuine WESCO chains or those injure operator and damage chain. A loose chain recommended for Guide Bar.
-
Page 15: Before Operation
If there is no oil pattern, despite a full oil reservoir, Fully Charged Green on contact a WESCO customer service agent or a WESCO- approved service agent. WARNING: When battery charge runs out after Caution: Do not touch the ground with the continuously use or exposure to direct sunlight chain. -
Page 16: Operation
OPERATION saw body as possible. Hold saw firmly in place to avoid possible bouncing or skating (sideways movement) of 1. SWITCHING ON AND OFF (SEE FIG. G) saw. Attention: Check the battery packs before (7) Guide the saw using light pressure and do not put using your cordless tool. -
Page 17: Maintenance
6. Do not operate the chainsaw with arms fully is necessary, use only the guide bar specified for your extended, attempt to saw areas which are difficult to saw in the repair parts list or on the decal located on the reach, or stand on a ladder while sawing (See Fig. -
Page 18: Troubleshooting
TROUBLESHOOTING Symptom Possible Cause Remedy Charge both the battery packs. Low battery charge. Chainsaw fails to Check to see if the chain brake is in Chain brake not in the proper operate. position 1 . Refer to THE CHAIN position. BRAKE section for details. -
Page 19: Fcc Part
Supplier’s Declaration of Conformity Product Description: Battery charger Model Number: WS9919 Trade Name: WESCO This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
Need help?
Do you have a question about the WS8303U and is the answer not in the manual?
Questions and answers
Где я могу приобрести запчасти к пиле ( не включается ) , мастерскую не предлагать !!!