Table of Contents
Advertisement
Operating Instructions and Parts List, Form No. 1000031, Back sheet 1 of 7
This is the safety alert symbol.
It is used to alert you to potential personal injury
hazards. Obey all safety messages that follow this
symbol to avoid possible injury or death
DANGER
Denotes an imminently hazardous situation which, if
not avoided, will result in death or serious injury.
WARNING
Denotes a potentially hazardous situation which, if not
avoided, could result in death or serious injury.
CAUTION
Denotes a potentially hazardous situation which, if not
avoided, may result in minor or moderate injury.
CAUTION
Caution used without the safety alert symbol indicates
a potentially hazardous situation which, if not avoided,
may result in property damage.
IMPORTANT
Denotes an operating or service procedure or condition
considered essential for expedient and efficient
operation and service.
WARNING
It is the operators responsibility to read and
understand the following safety statements,
•
Only qualified operators should install, operate,
adjust, maintain, clean, repair, or transport this
machinery.
•
Inspect tool before use. Replace any worn or
damaged parts. Failure to observe these warning
can result in severe injury or death.
WARNING
Keep hands away from the cutter head
assembly head when cutting.
IMPORTANT SAFETY INFORMATION
To help prevent personal injury,
•
Always wear eye protection whenever
operating hydraulic equipment.
•
Always wear hearing protection as
required.
• Operation, repair, or maintenance of hydraulic
equipment should be performed by a qualified
person who understands the proper function of
hydraulic equipment per local directives and
standards.
• Hydraulic equipment must be assembled correctly
and then checked for proper function before use. Use
hydraulic components of the same hydraulic
pressure ratings. An appropriate hydraulic pressure
gauge is recommended to monitor pressure.
•
Never place your hands or other body
parts near a hydraulic fluid leak.
Never use your hands or other body parts
to check for a possible leak.
High pressure fluid can be injected under your skin
causing serious injury and/or infection.
WARNING
• Do not exceed cutting capacity of materials listed on
sheet one. Cutting of too large or too hard materials
could cause blades to shatter and cause injury.
• This tool is not insulated. When using this
unit near energized electrical lines, use
proper personal protective equipment.
CAUTION
• Do not cut piano or music wire.
• Do not operate cutter with top support open.
IMPORTANT
• Properly dispose of all fluids, components, and
assemblies at the end of their useful life.
• Hydraulic fluid should be compatible with all
hydraulic components.
Advertisement
Table of Contents
