Air Conditioner Controls - GE ASH06LK Owner's Manual And Installation Instructions

About the controls on the air conditioner—models with touch pads.
Features and appearance will vary.
COOL On
ENERGY
SAVER On
On/Off
Turns air conditioner on and off.
Display
Displays the set temperature or time
remaining on timer.
Mode
Use to set the air conditioner to Cool or Fan
mode.
Increase
Use to set temperature when in Cool mode.
Fan
Use to set the fan speed at Low, Med or High .
Energy Saver–
On— The fan and compressor cycle on and
off. This results in wider variations of room
temperature and humidity. Normally used
when the room is unoccupied. Note: The fan
will continue to run for a short time after the
compressor cycles off.
Off— The fan runs all the time, while the
compressor cycles on and off.
This switch must be set at Off in order to use
the fan settings (on the mode control).
Remote Control
To ensure proper operation,
aim the remote control at the signal
receiver on the air conditioner.
The remote control signal has a range
of up to 21 feet.
4
FAN On
TIMER On
ENERGY
SAVER On
OR

Air Conditioner Controls

/Decrease Pads
Controls the fan.
COOL On FAN On
Timer
On— When the air conditioner is off, it can be
set to automatically turn on in 1 to 24 hours
at its previous setting. Each touch will set the
time in hours.
Off— When the air conditioner is on, it can be
set to automatically turn off in 1 to 24 hours.
Each touch will set the time in hours.
To cancel the timer, press the Timer pad
until the display time disappears.
Remote Control Signal Receiver
Make sure nothing is between the air conditioner
and the remote control that could block the
signal.
Make sure batteries are fresh and installed
correctly—see the Care and Cleaning section.
TIMER On
Remote
Control