Advertisement
INSTRUCTIONS
NICE HSKIT2GWFR ALARM SYSTEM SET
Programming the HSCU2 alarm control panel:
01. In the main menu, touch "Alarms"
02. Make sure the alarm system is disarmed. If it is not, ask the user to disarm it.
03. Scroll vertically with the arrows and select "Menu"
04. a) With EN 50131 disabled (first installation): enter the "Installer code" (this must
already have been programmed). b) With EN50131 enabled: Enter the "User code",
scroll through the menu and select "Installer code" and enter the installer code in the
following page.
05. Confirm with "OK".
06. Select the option you desire as indicated below (example: "Tools" > "Remote
controls" ...).
Visit our Website. www.alloremotecontrol.com
Main menu – Devices:
To acquire and program all alarm system devices, select Devices and follow the
instructions in the submenus
Visit our website: www.Alloremotecontrol.com
families:
Advertisement
Table of Contents
Related Manuals for Allo RemoteControl NICE HSKIT2GWFR
Summary of Contents for Allo RemoteControl NICE HSKIT2GWFR
- Page 1 INSTRUCTIONS NICE HSKIT2GWFR ALARM SYSTEM SET Programming the HSCU2 alarm control panel: 01. In the main menu, touch “Alarms” 02. Make sure the alarm system is disarmed. If it is not, ask the user to disarm it. 03. Scroll vertically with the arrows and select “Menu”...
- Page 2 Programming the access codes: INSTALLATION: This procedure sets the codes used by users for arming/disarming the system. Up to 32 codes can be programmed. Each must have 4 parameters, including assignment of the zones (A, B, C, D, E, F) which the code will be able to arm/ disarm 01.
- Page 3 Programming an intrusion detector: 01. Select the zone to assign the detector to: “Alarm zone A”, B, C, D, E, F. 02. Select the detector: touch “Add 1 detector”. 03. Fill out all fields as follows: Delay: Touch “Delay” and enter the alarm delay (0 Sec = alarm is sent immediately).
Need help?
Do you have a question about the NICE HSKIT2GWFR and is the answer not in the manual?
Questions and answers