Related Manuals for Sanyo DC-C10
Summary of Contents for Sanyo DC-C10
- Page 26 3CD Changer Mechanism This manual explain how to remove and assemble by 10 illustration as follows. May help the service manual of DC-C10, C30, C50, C70 Series. Note: A name in this explanation uses a name mentioned in mechanism number list.
- Page 27 3 CD MECHANISM INSTRUCTION B. Disassembly the DRAWER 2 (Step 1) 1. Slide CM35 SLIDER 1 back and forth(Fig.1). Drawer's lock is released. 2. Pull CM02 DRAWER 2 half way out. SLIDER 1 CM35 CLOSE OPEN PULL Fig.1 PUSH C. Disassembly the DRAWER 2 (Step 2) 1.
-
Page 28: Bevel Gear
3 CD MECHANISM INSTRUCTION D. Position confirmation 1. Rotate CM18 BEVEL GEAR 4 to check CM12/CM13 (or CM14) CARRIAGE movement and position. If it is good, two carriages are the same position at the end (front position) (Fig.3). BEVEL GEAR 4 CM18 NO.2 CARRIAGE CM13... - Page 29 3 CD MECHANISM INSTRUCTION 4. Push CM13 CARRIAGE No.2 up with your fingers (Fig.6). BEVEL GEAR CM18 NO.2 CARRIAGE CM13 Fig.6 5. Place CM12 CARRIAGE No.1 as shown in the illustration (Fig.7). 6. Turn CM18 BEVEL GEAR 4 to slide the carriage into its position. BEVEL GEAR 4 CM18 NO.2 CARRIAGE...
- Page 30 3 CD MECHANISM INSTRUCTION F. CARRIAGE Playback positon If the CARRIAGE is wrong position, 1. Slide CM35 SLIDER 1 to lift CM32 CLAMPER up (Fig.8). CLAMPER CM32 SLIDER 1 CM35 CLOSE OPEN PULL Fig.8 2. Place CM14 CARRIAGE No.3 on CM43 CARRIAGE LIFT UP (Fig.9). 3.
- Page 31 3 CD MECHANISM INSTRUCTION G.Mechanism Assembly (Fig.10) 1. Make sure CM18 BEVEL GEAR 4 is in the place. 2. Make sure CM39 GEAR IDLER A2 is in the place. 3. Match CM27 BEVEL GEAR 1 as shown in the illustration (Fig.11). 4.
- Page 32 HOW TO CHECK THE UNIT 1. Connect the AC power cord. 2. Press the Power switch to turn on the power. 3. The unit will be set into Initial settings as shown below. If the unit is mulfunction, the unit will stop in the step. Turn on the power Notes: Discriminates the carriage No.
- Page 33 *The gear inside HOLDER(CM04) "R" engaged at the displaced position Displayment occurs *The gear of HOLDER(CM04) "R" displaced with the gear of CARRIAGE *PC BOARD B and Home switch circuit (CM06) defective *Control PC BOARD attached in the final process Rotates MOTOR DRAWER (CM49) defective *PC BOARD (CM06,07) incompletely soldered...