Table of Contents
Advertisement
Connections – Back
Some of the connectors on the base can be changed or configured to customer
specifications.
For example; The Data In connector can be either a 3 pin XLR for RS485 data input or an
RJ45 for IP connection. The RJ45 can be configured as a loop-thru, via the slip rings, to the
RJ45 at the top.
Data In
As standard this is an XLR3 connector for D*
Protocol over RS485. It can be replaced with
an RJ45 connector and an
inside. This can receive either D* or M*
Protocols over IP. Alternatively, this can be
connected through the slip rings (if fitted)
directly to the RJ45 Loop connector at the
top.
Power 48v
A 48v PSU is supplied with the unit which connects here. D* data can also
be injected into this socket if required. See Pinout details below.
Dsub9
This connector is designated for motion control inputs and outputs. DMX,
Free-D
Free-D
The
numerical format which allows for 360 degree positioning data. The data
format for this connector is configured from our
or supplied with the customer requirement pre-set.
IP interface
or
Mstar
protocols can be used for positional control. Metadata, in
or
Mstar
format is continuously output on this connector.
Free-D
format can be either original angular format or RAW as a
fitted
6
Multi Function Controller
Advertisement
Table of Contents
