BR Remote Protean XMi Instructions Manual page 10

To test the unit, use one of the methods below.
RS485 Connection
PSU
12v
IP Connection
PSU
12v
IP addresses are pre-configured and use UDP multicasting as the default setting. This gives
the lowest latency and control response. The system is plug-and-play if used on the same
network. To use it over the internet it is best to set up a VPN. (Virtual Private Network). No
re-configuration is required if this is done.
To re-configure the IP settings contact BR Remote for a link to the web tools.
Network
10
PSU
48v
PSU
48v