Advertisement
CROSSBAR RETROFIT SEQUENCE
FRONT MOUNTING BRACKETS
Remove and retain Channel End
1.1
Caps and screws for Step 2.2
Prime Design Limited Warranty. Seller's sole and exclusive warranty (and Buyer's sole and exclusive remedy and Seller's entire liability for any breach thereof) with respect to the Goods is set forth in the Limited Warranty document available at primedesign.net/warranty-liability
(the "Prime Design Limited Warranty"). ▪ TM & © 2020 PRIME DESIGN. PROTECTED BY ONE OR MORE OF THE FOLLOWING PATENT NO.'s 6427889, 6764268, 6971563, 8991889, 9415726, 9506292, 9481313, 9776476, 9796340, 10470565, 10486608 AND OTHER PATENTS PENDING
2
1.2
Loosen
Nuts
NOTE: Crossbars and the Base Mounting
System are shown for illustrative purposes
only. The instructions contained in this
Manual will apply across many model
combinations and variations.
1
CENTER CROSSBAR
Place the new Mounting
2.2
Brackets under the Front
Crossbar as shown then
reinstall the End Caps.
Figure A
Slide front Mounting
2.1
Brackets and adjust
as shown in Figure A.
Loosen bolts
36.00"–60.00"
Left Rear
3
Advertisement
