Advertisement
WARNING
1. Read the manual and follow the instructions relating to safety tips, correct and complete product assembly, setting into service, use and maintenance.
2. For your own safety, always heed the advice and warnings in these instructions.
3. Non-compliance with these operating instructions may expose the user to serious danger. Only use the product in the places and conditions in which it is intended.
4. The user should always sit in the centre position of the product for proper balance, otherwise it may cause serious injury or even death.
5. This is not a life-saving device. Do not use as a flotation device.
6. Keep away from heat, rough surfaces and all sharp objects.
7. Tilting and drowning may occur with uneven distribution of people or load!
8. Only to be used in water in which the child is within its depth and under adult supervision.
Setup Instructions
1. Check the product for tears or punctures. Do not use a damaged product or one with defects.
2. To Inflate: Pump air in through the air valves one by one, starting from the base. When finished, close the valve caps and push the valves into the product body to get a flat surface.
IMPORTANT: Always fully inflate all air chambers. The inflated product should be firm but not too hard. Do not over-inflate or use a high-pressure air compressor to avoid leak or
damage. If you cannot push the valve back into the product, deflate slightly.
3. To Deflate: Squeeze the base of valves to release all the air. Close the valve caps when finished.
If the Product is Equipped with 2-in-1 Valve:
1. Inflate
Remove Top Cap and press down
Inflation Valve. Then, pump air in.
Note: Before inflating, please press
Inflation Valve firmly into the exhaust port.
Top Cap
Inflation Valve
Maintenance & Storage
1. To Clean: Rinse with lukewarm mild soapy water and hang to dry. Never iron or brush. Do not clean with solvent cleaning agents - this will damage the product permanently.
2. Do not drag the product while it is loaded, sharp objects can puncture the product.
3. To Repair: Clean the repair area. Press the included repair patch firmly over the puncture/hole/leak, then wait for 30 minutes before re-inflating.
IMPORTANT: Do not modify this product or use any parts and accessories not supplied by the manufacturer. Replace defective parts according to the instructions of manufacturer.
4. To Store: Deflate and completely air-dry the product. Gently fold, and store it in a dry place away from direct sunlight. The original packing carton can be used for storage.
2. Deflate
Remove Top Cap and Inflation
Valve. Then, let all the air out.
Exhaust Port
Inflation Valve
6
3. Seal
Close Top Cap tightly to seal the
valve after inflation/deflation.
EN
To lock, press the valve
all the way down.
Advertisement
