Osprey Steam 'N' Vac Operating Procedure

OPERATING PROCEDURE
The following rules must be observed when using the Steam 'N' Vac
Always Check daily before use that the power supply cable, plug
•
and sockets are in good condition; check for visible signs of
damage (do not use if damaged)
Follow the correct procedure when filling the water
• Always
reservoirs and waste tank
Always Wear full PPE when working in confined spaces - mask,
•
goggles, gloves, overalls
Operating Procedures on the Steam 'N' Vac
Unclip handle Remove transparent
cover
Fit funnel and fill with Plug the power cable into a
2 ltr of cold tap suitable electric socket.
water. Replace Press the on / off switch on
reservoir filler plug the back of the machine
•
•
Remove waste Fill with cold water
bucket between minimum
and maximum mark
Press the steam
peddle switch once,
the amber light will
start to flash
Never allow any part of the Steam 'N' Vac to be immersed
in water
allow children, inexperienced, untrained or
Never
unauthorised people access to the Steam'N' Vac
Replace bucket
cover and handle
Wait approximately 4 Open the front panel
minutes until the and connect the
amber light is steady steam hose
Remove reservoir
filler plug
Turn the steam
control knob to
required setting