4-2-4. No Video (Tuner DTV)
Note
Refer to the next page to check the location such a CN201 or IC201 SVC Manual mentioned.
Symptom
•
Audio is normal but no picture is displayed on the screen.
•
Check the DTV source.
Major
•
Check the Tuner.
checkpoints
•
This may happen when the LVDS cable connecting the Main Board and the Panel is
disconnected.
1
Diagnostics
2
2
Caution
Make sure to disconnect the power before working on the IP Board.
Power indicator LED is off.
Lamp(Backlight) on, no video ?
Yes
Check the RF source and check the
connection of RF cable.
Yes
Check the 'signal strength' in Self
Diagnosis menu Strength is enough ?
Yes
Check the Power of Tuner ?
Pin #1 of Tuner : A3.3V_Tuner
-
Pin #4 of Tuner : A1.8V_Tuner
-
Yes
Check the LVDS clk signal at output of
Main board. (TX)
TX6_CLK : TCON SDA
-
TX8_DATA : TCON SCL
-
Yes
Check the LVDS cable?
Replace the T CON / LCD panel?
No
Check a set in the 'Stand-by mode'.
No
Input the RF source properly.
No
Check the D-TV source.
No
Change the Main Ass'y.
Check IC1400(NT14U)
No
Change the Main Ass'y.
No
Please, Contact tech support.
4. Troubleshooting
4-13