JAVAC NBM-500L Manual page 3

CONNECTING THE WIRE-FEEDER/GENERATOR INTERCONNECTION CABLE
This cable connects the welding machine to the wire-feeder.
WARNING: Do not disconnect the wire-feeder until the
machine has been switched off (see paragraph "Alarm con-
ditions").
 DIRECT-POLARITY welding
Connect up the interconnection cables (power cable, ancillary
Figure 1
wiring and gas tube) to the special attachments and couplings
shown in .
The delivery and return water tubes, used for cooling the
torch of the welding machine, are part of the interconnection
cable and should be connected as follows:
interconnection cable on generator side: connect up air plug
and welding cable (positive) to their rapid couplings;
wire feeder side connecting cable: connect up air plug, air
pipe and welding cable (positive) to their rapid couplings
Figure 1
( );
Figure 1