Sony ICD-SX68 Operating Instructions Manual page 77

Symptom
The IC recorder or
"Memory Stick" cannot be
properly connected.
The IC recorder does not
operate.
Messages cannot be
played back./Playback
sound volume is too low.
Saved message files
cannot be played back or
edited.
Remedy
Check that the installation of the software has been successful.

Also check the connection as follows:
When using an external USB hub, connect the IC recorder directly

to the computer.
Disconnect and then connect the cable with the IC recorder.

Connect the IC recorder to another USB connector.

Your computer may be in the system standby/hibernate mode.

Do not let your computer enter into the system standby/
hibernate mode while being connected to the IC recorder.
You may format the memory of the IC recorder. Use the IC

recorder formatting function to format the memory.
No sound board is installed.

No speaker is built-in or connected to the computer.

The volume of the sound is turned down.

Turn up the volume on the computer. (Refer to the instruction

manual of the computer.)
The volume of WAV files can be changed and saved using the

"Increase Volume" feature of the Microsoft Sound Recorder.
You cannot play back a message whose file format the Digital

Voice Editor software does not support. Depending on the
file format, you cannot use part of editorial features of the
software.

GB