9. Remove the rocker cover and gasket.
10. Loosen the rocker shaft retaining bolts (which
also serve as head bolts) evenly and alternately
and remove the rocker shaft assembly.
NOTE: Leave bolts in the rocker shaft supports dur-
ing removal, as they retain the support on the shaft.
11. Remove pushrods in turn and place in a
numbered rack to maintain the same position for
reassembly.
12. Remove remaining cylinder head bolts by
working progressively from each end of the
cylinder head towards the centre.
13. Carefully lift the cylinder head assembly away
from the engine block.
SECTION 10 – ENGINE – CHAPTER 1
10-30
30
31
32
33