Advertisement
Other SMS commands:
Output Control:
The output relay can switch loads up to
10amps at 240vAC so be careful. Use a
qualified electrician if not sure.
To pulse the relay just call and the relay will
switch for 3 seconds. Here are some extra
relay control commands:
Turn the relay ON
#REL=ON#
Turn the relay OFF
#REL=OFF#
Pulse the relay for 4 seconds
#REL=PULSE#
Other bits and bobs:
Status message
#STATUS#
shows status on all the inputs and the relay
plus the signal level (0 to 20).
Make a brief free (3 ring) call after each SMS
alert (as an extra prompt to read the SMS)
don't answer or reject the call or it won't be
free!
#CALL=ON#
Set back to SMS only (default)
#CALL=OFF#
Change how long the input needs to be closed
before it sends a message (input delay)
#ITD=4#
Can be between 1 and 9 seconds
Send a regular "all ok" status message
#PERIODIC=4#
(No of weeks - default is 4)
Allow only users to call to pulse the relay
#WHL=ON#
Allow any caller to pulse the relay (default)
#WHL=OFF#
Have you messed up?
Reset (everything but the alert messages)
#RESET#
Power Failure Alerts
There is an internal rechargeable battery
installed
in
the
GSMWhitebox2
provides power failure and power restore
alerts. Make sure the small battery switch is
turn to the ON position and when the external
power has failed a power fail message is sent
to all recipients – It waits about 5 minutes to
make sure is a proper power fail and not just a
blip.
When power is restored a message to confirm
all is tickity boo is sent.
Wiring:
The inputs are volt-free so don't put any
voltages on them or they will go pop.
To trigger a message close or open the circuit
between INput and COMmon
Look for a blue flashing LED to check you have
a signal. The green ready LED will flash when a
command/message is being sent – you may
also hear some electronic weird noise too.
Any questions just ask:
sales@sendtech.co.uk
Call: 01488 762 763
©SeNd Technology 2020 V3
which
Advertisement
