Page 1
HDTV Chassis : APT52A Model: HCH551WX//XAA H D T V C O N T E N T S Precautions Specifications Alignment and Adjustments Troubleshooting Exploded View and Parts List Electric Parts List Block Diagrams Wiring Diagram Schematic Diagrams...
The current measured should the XÐray Protection Specifications Label, and not exceed 0.5 milliamp. Reverse the power- the Product Safety and X-ray Warning Note on plug prongs in the AC outlet and repeat the the service data schematic. test. Samsung Electronics...
Page 4
14. Components, parts and wiring that appear to have overheated or that are otherwise damaged should be replaced with parts that meet the original specifications. Always determine the cause of damage or overheat- ing, and correct any potential hazards. Samsung Electronics...
(except lamp) are damaged, replace the whole optical engine. 5. Check the insulation between the blades of the AC plug and accessible conductive parts (examples: metal panels, input terminals and earphone jacks). Samsung Electronics...
4. Do not use freon-propelled chemicals. These unpackaged replacement ESDs. Motions such can generate electrical charges that damage as brushing clothes together, or lifting a foot ESDs. from a carpeted floor can generate enough static electricity to damage an ESD. Samsung Electronics...
Cable Tuner : 75W Unbalanced Coaxial Reverse AGC Consumption 245 Watts Power Requirement 120V/60Hz 15 Watt/CH x 3 Sound Output Dimensions (W x D x H) 1345 x 629 x 1448mm (55 x 25 x 57 incher) Weight 91 kg Samsung Electronics...
ÒDisplayÓ ® "8" ® Ò2Ó ® Ò4Ó 3-2 Factory/Service Mode 3-2-1 Aging Mode The Aging Mode is activated by pressing the remote-control in the following sequence: Power OFF ® Mute ® 1 ® 8 ® 5 ® Power ON Samsung Electronics...
Page 9
2 R Y R 9)) 3 R Y B 8 )) 4 G Y R 8)) 1 SUB BRI 10 4. The Volume keys increase or decrease the adjustment values. 5. Cancel the Adjustment Mode by pressing the ÒMenuÓ key. Samsung Electronics...
Page 10
SIG SEL INPUT SIGNAL SELECT 0 ~ 3 FIXED SUB BRI1 SUB BRIGHT ADJUST 0 ~63 W/B ADJUSTMENT SYNC SEL SYNC SEPARATION SIGNAL SELECT 0 ~ 3 FIXED R DRIVE RED OUTPUT SIGNAL DRIVE ADJUST 0 ~63 W/B ADJUSTMENT Samsung Electronics...
Page 11
E -W CORNER 0~3.2V ADJUST TRAPEZIUM TRAPEZIUM 0~1.2V ADJUST H-COMPENSATION H-COMPENSATION ADJUSTMENT 1.6~7. 3V 8 FIXED V -F CORR V -F CORR FIXED 4 : 3 R 4:3 R SHIFT FIXED 4 : 3 L 4:3 L SHIFT FIXED Samsung Electronics...
Page 12
FIXED INPUT LEVEL ADJUSTMENT 0 ~15 FIXED STEREO ALIGNMENT DATA 0 ~31 FIXED FOR WIDEBAND EXPANDER STEREO ALIGNMENT DATA 0 ~31 FIXED FOR SPECTRAL EXPANDER TIMING CURRENT ALIGNMENT DATA 0 ~ 7 FIXED STEREO ADJUSTMENT ON/OFF ON/OFF FIXED Samsung Electronics...
Channel and Volume keys (Up/Down), and line.) press the Tridimensional Sound key, and then adjust so that the top and bottom margins are equal. (Use the Volume +/- keys.) If necessary, readjust the top and bottom margins using a center magnet. Samsung Electronics...
Page 15
5. Press the Menu key to exit. 2. Input a crosshatch pattern. 3. Cover the lenses that are not being adjusted. 4. Connect a convergence jig and read data. 5. Adjust the lens for best focus. (See Fig, 3-1, next page) Samsung Electronics...
Page 16
1. Cover the Red and Blue lenses. Lens Color Aberration Change 2. Adjust VR49 (located on the deflection PCB, Orange - Crimson H-Parabola). Blue - Red Purple - Green 3. Balance the left and right sides of the dynamic focus lines. Samsung Electronics...
Page 17
3. Input a lion head pattern. convergence drift is seen, repeat the adjustments. 4. Enter the Convergence Mode by pressing the remote-control keys in the following sequence: 20. Press the Exit key to enter the TV mode. Factory ® Mute ® Display. 3-10 Samsung Electronics...
5. Adjust the Red lens using the same method as with the Green lens. 6. Note: The Blue lens is not adjusted because its focus varies little (VM-coil is installed). 7. After the adjustments are completed, disconnect the jig pin connector. Samsung Electronics 3-11...
Page 19
Cancel (Press to revert to FACTORY PLAY the previous values while Factory (Press to call the convergence adjustments are made.) the factory default values.) PAUSE STOP 3-Speed (Press for OSGM Inspection.) 3-SPEED S A M S U N G 3-12 Samsung Electronics...
Page 21
After selecting the cursor move button, press the F-Cursor Button and B-Cursor Button (See below) 3. Convergence Picture Move Button Use the Channel and Volume keys to move the cursor. (Continuous, Normal) The pattern looks like this: step step step step < HORIZONTAL > < VERTICAL > 3-14 Samsung Electronics...
Page 22
7. Cancel (S.STD) Press to revert to the previous data 8. Save (MTS) After the convergence adjustments are completed, press to save data. 9. Exit (S.SEL) After the convergence adjustments are completed, press to exit to TV mode. Samsung Electronics 3-15...
4-2 No Raster (No Picture, Sound Ok) On Power OFF, Open Check the CRT Output Check if R437A is open (210V line resistance) After Power ON, Replace IC471 Check IC471 Pin 9 and Check the high Voltage Outputs Samsung Electronics...
Page 25
4-4 No Picture (Power ON, Raster and Sound OK) Abnormal Check CN501 pins 1,3,5 (See the waveforms) Abnormal Check the circuitry near TDA6120Q and IC Abnormal Check Q212,Q213,Q214 Normal Replae Q212, Q213,Q214 Normal Check the circuitry near IC201, IC202 Abnormal Replace IC201,IC202 Check the digital board Samsung Electronics...
Page 26
Check the circuitry near of QN21,QN22,QN23 Normal Replace QN21, QN22,QN23 Abnormal Check the circuitry near of ICN05, ICN06, ICN07 Normal Replace ICN05, ICN06, ICN07 Check Abnormal the circuitry near of IC603,604,605,606,607 Normal Replace IC603, Check the Digital Board 604,605,606,607 Samsung Electronics...
Page 27
Check the Power Line (Def) High Check the Horizontal Check GT31 H-Drive Check the base of Q486 Oscillation Check the Horizontal Output Check the High Short CN201 pins 5,6 Voltage Output After connecting the wires for CN201, check Vertical Deflection Samsung Electronics...
Page 56
Tone Ctrl VOL Ctrl CS4226 TDA8425 L/R/C/LS/RS/W Audio Data 0/1/2 SSM2160 AMP BOARD Digital Board LS/RS/W External Digital Audio IN TO OUTPUT JACK Digital Audio Out R.G.B R/G/B CRT BOARD Interface CXA2011Q 2H/2V SYNC Y/U/V R/G/B R,G,B Controller CXA1839Q Samsung Electronics...
Page 57
Q472,T451 Q473 H-Blk POWER 12v Regulator IC421 TO HV CRT PWM Output Sync Lock TO FOCUS R487,C487 Q485,T481 TO ABL T444 X-Ray Pro PWM Generator Q483,IC481 IC471 : DL494C Error Feedback PCB : SIZE 330 x 245MM R471,VR471 Samsung Electronics...
Page 58
STAND - BY CONV SWITCHING IC STR-6709 7806 CONV LINE FILTER 7V / 0.2A 1mH/5A PHOTO - COUPLER ERROR AMP SE012N PS2561 - 8.5V/-0.2A 7805 STAND BY P i = 3 2 0 W AC120V ONLY / MORE THAN 8A Samsung Electronics...
Page 59
VM COIL B +130V VM OUT VCC 13.5V SOUND RELAY, VM conv module +5V REG IC SI3050C +6.5V conv module -5V REG IC KA7806 -7.5V conv amp +30V POWER SUPPLY -30V conv amp sound amp +15V sound amp -15V Samsung Electronics...
Page 60
Y/C Separation Y Noise Reduce Bust-Lock 8bit Vertical peaking TMS4C1060BDJ Clock Generator 9bit 1 Mbit(4x256K) Field Memory DATA CLOCK Y OUT L.P.F 2Vp-p 3.3V Amp. Regulator 6MHz VIDEO IN 2Vp-p L.P.F Amp. 6MHz C OUT B.P.F Amp. Regulator 3.58MHz Samsung Electronics...
Schematic Diagrams 9. Schematic Diagrams 9-1 MAIN (1/4) IF CVBS OUT Cable Tuner IF DG Tuner IF : Power Line : Signal Line Samsung Electronics...
Page 64
Schematic Diagrams 9-2 MAIN 2/4 D-Bd B-out D-Bd R-out D-Bd G-out SSCP VM Y Out : Power Line : Signal Line Samsung Electronics...
Page 65
Schematic Diagrams 9-3 MAIN 3/4 TP10 3D-COMB Input Video TP13 TP12 TP11 TP11 3d COMB Y-out TP10 3D-COMB C-out TP12 TP14 TP13 V-Y-out TP14 SYNC : Power Line : Signal Line Samsung Electronics...
Page 66
TDA9141 #14 U out TP18 TP22 TP17 TP18 TP15 TP16 TP19,20 Panorama #43 TP23 TP21 Panorama - Y Panorama - V TP22 TP23 Panorama - U TP24 TP24 NTSC-Y out TP25 TP26 : Power Line : Signal Line Samsung Electronics...
Page 67
Schematic Diagrams 9-5 3DCOMB1 : Power Line : Signal Line Samsung Electronics...
Page 68
Schematic Diagrams 9-6 IF_MODULE : Power Line : Signal Line Samsung Electronics...
Page 69
TS23 H-SYNC TP31 TP29 TS47 VM OUTPUT TP30 TP30 TS12 RV TP32 TP31 TS10 RH TP27 TP28 TP33 TP34 TP32 TS15 GH TP35 TP33 TS17 GV TP34 TS19 BH TP29 TP35 TS20 BV : Power Line : Signal Line Samsung Electronics...
Page 70
TP37 TP35 TP36 TP36 DEF TS2 2V-SY TP37 DEF TS3 V-BLK TP43 Q422 C H-DRIVE TP42 TP40 TP41 TP39 TP44 DEF TS9 H-OUT DEF TS10 E/W OUT TP45 TP46 DEF TS14 DE-OUT : Power Line : Signal Line Samsung Electronics...
Page 71
Schematic Diagrams 9-9 CRT TP51 CRT R-IN TP47 TP48 CRT G-IN TP49 DRT B-IN TP52 TP47 TP48 TP50 TP49 TP51 TP50 TP52 TP53 TP53 : Power Line : Signal Line Samsung Electronics...