Page 1
H RC -1 00-RS-H W Hard Wire Rain Sensor I N S T R U C T I O N M A N U A L Model 04007-24 rC...
Page 2
Once the sensor is mounted, run the wire to the controller, using wire clips every few feet to fasten it. If an extension to the wire provided is needed, use the Thank you for selecting the HRC-100-RS-HW Hydro-Rain sensor. This sensor ®...
Page 3
OPERATION CHECK TO VERIFY CORRECT WIRING MAINTENANCE Turn on one zone of the sprinkler system that is visible while you are in reach There is no required maintenance for the unit. The sensor does not have to be of the sensor. Manually depress the spindle at the top of the sensor until you removed or covered for winterizing purposes.
Page 4
(proof of purchase required). We reserve the right to inspect the defective part Third Normally-Open Lead prior to replacement. Hydro-Rain will not be responsible for ® consequential or incidental cost or damage caused by the product failure.
Need help?
Do you have a question about the HRC-100-RS-HW and is the answer not in the manual?
Questions and answers