Ayce LMA8050D Operator's Manual page 106

After mowing
• Check all screws and nuts before the next use. Tighten all loose screws.
• Empty the grass catcher box (4) before the next use.
• Make sure that the mower is not parked next to a source of danger. Escaping gas can
cause explosions.
• Only original parts or parts approved by the manufacturer may be used for repairs
(see asddress on guarantee certificate).
• In case of longer idle periods of the mower, empty the petrol tank with a petrol
suction pump.
• maintain the device.
MAINTENANCE AND CARE
WARNING!
1. Remove the battery from the machine before any maintenance and repair work on
the lawn mower.
2. The cutting tools are sharp! Wear safety gloves.
3. Regularly check the machine before starting work. Damaged parts must be repaired
or replaced by an authorized service centre before you start work with the machine.
Only ever use original accessories and spare parts. If possible, always clean the
machine straight after mowing.
• Remove the battery.
• Remove the grass box.
• After every mowing, clean the lawn mower with a hand brush.
• Carefully remove grass residue from the cutting area. Loosen stuck grass residue
with a wooden stick.
• Keep the ventilation slots clean and free from dust.
• Never use water to clean or spray the machine. Clean the motor casing with a
damp cloth and never use detergents or solvents! This may damage the
machine's plastic parts. Carefully dry the motor casing afterwards.
4. Check the condition of the blades.
Grass catcher box
• You can use a hose to thoroughly clean the grass box.
Removing/sharpening the cutting blade (Fig. 18)
If the blades' cutting performance decreases, you can remove the blades and have
them sharpened by a certified specialist.
During assembly, thoroughly clean the area of contact of the flange and the blades.
Tighten the clamp screw firmly. (Fig.18)