Sony CMT-G2NIP Operating Instructions Manual page 61

There is a severe hum or noise.
,
Move the system away from any sources of noise.
,
Connect the system to a different wall outlet.
,
Install a noise filter (not supplied) to the power cord.
The remote does not function.
,
Remove any obstacles between the remote and the
remote sensor on the unit, and position the unit away
from fluorescent lights.
,
Point the remote at the sensor on the unit.
,
Move the remote closer to the system.
,
The batteries may be run down. Replace the batteries
with new ones.
The STANDBY indicator remains lit after
unplugging the power cord.
,
The STANDBY indicator may not turn off
immediately after unplugging the power cord. The
indicator will turn off after about 40 seconds. This is
not a malfunction.
CD/MP3 player
The sound skips, or the disc will not play.
,
Wipe the disc clean, and replace it.
,
Move the system to a location away from vibration
(for example, to the top of a stable stand).
,
Move the speakers away from the system, or place
them on separate stands. At high volume, speaker
vibration may cause the sound to skip.
Playback does not start from the first track.
,
Return to Normal Play by pressing PLAY MODE
repeatedly until both "PGM" and "SHUF" disappear.
Starting playback takes more time than usual.
,
The following discs can increase the time it takes to
start playback:
• a disc recorded with a complicated tree structure.
• a disc recorded in multisession mode.
• a disc that has not been finalized (a disc to which
data can be added).
• a disc that has many folders.
Tuner
There is a severe hum or noise, or stations
cannot be received ("TUNED" or "ST" flashes
on the display).
,
Connect the antenna properly.
,
Find a location and an orientation that provide good
reception, and then set up the antenna again.
,
Keep the antennas away from the speaker cords and
the power cord to avoid picking up noise.
,
Turn off nearby electrical equipment.
The DAB/DAB+ radio station is not received
properly (CMT-G2BNiP only).
,
Check all antenna connections, then perform the
DAB Initial Scan procedure (see "Performing a DAB
Initial Scan manually" (page 31)).
,
The current DAB/DAB+ service may not be
available. Press +/– to select a different service.
,
If you have moved to another area, some services/
frequencies may have changed and you may not be
able to tune into your usual broadcast. Perform the
DAB Initial Scan procedure to re-register the
contents of broadcasts. (Performing this procedure
clears all previously stored presets.)
The DAB/DAB+ broadcast has been
interrupted (CMT-G2BNiP only)
,
Change the location of the system or adjust the
orientation of the antenna to increase the indicated
value of the signal quality. Refer to "Changing the
display settings" (page 59) for further details on the
signal quality.
iPod/iPhone
There is no sound.
,
Make sure the iPod/iPhone is connected securely.
,
Make sure the iPod/iPhone is playing music.
,
Make sure the iPod/iPhone is updated with the latest
software. If not, update the iPod/iPhone before using
with the system.
,
Adjust the volume.
The sound is distorted.
,
Make sure the iPod/iPhone is connected securely.
,
Turn down the volume.
,
Set the "EQ" setting of the iPod/iPhone to "Off" or
"Flat."
61 GB