lowest level.
4.
If the device is removed from contact with the skin, the
green indicator will continuously flash and beep for one
minute before the device automatically switches off.
Remote control operation
The remote control and the power device are set and
connected as factory default settings.
Connection: If the remote control is disconnected from the
power device, long press the power button to turn on the
device and press the "-" key for 6 continuous times. The green
indicator will flash continuously, and the device will beep to
indicate that it is ready to connect. Press any button on the
remote control to connect. Once the power device shuts
down automatically, the signal is successfully connected.
Disconnecting the remote: Turn on the power device
and long press the "-" button. When the device beeps for
approximately 3 seconds, release the button and then press
the "-" button again. The device will shut down automatically
and the remote control will be disconnected from the power
device.
Charging instructions
Before use, charge the device using the attached USB cable.