x.1.4.AGC Figure of Merit...................................................................................................................................... 60
x.2.Summation...................................................................................................................... 60
z)Servicing Procedures.................................................................................................64
z.1.1.Front Panel Removal.................................................................................................................................... 64
z.1.2.Front Panel Installation................................................................................................................................. 65
a)Make sure that the preselector shaft has these items installed in the following
order facing back from the panel: a flat washer, a lock washer, the nut and two
rubber "O" rings. The bushing for the Preselector shaft is installed from the front
b) Make sure that the PA Tune shaft has these items installed in the following
order facing back from the panel: a flat washer, a lock washer, the shaft bushing
and a large "O" ring. The front flat washer and nut are installed from the front
the main tuning dial.......................................................................................................66
the zero set shaft...........................................................................................................66
a)If the dial pointer is to the right of the zero marking, loosen the dial pointer drive
arm mounting screws, and move the dial pointer drive arm base to the right until
the dial pointer is at zero. Do not move the dial pointer drive arm base up or
aa)If the dial pointer is to the left of the zero marking, loosen the dial pointer drive
arm base- to the left until the dial pointer is at zero. Do not move the dial pointer
a)If the dial pointer is to the left of the "5" marking, loosen the dial pointer drive
arm mounting screws and move the dial pointer drive arm base up until the dial
HW & SB Series Manual
Page 6