Advertisement
Step 8. Insert the (3) F/M hex standoffs into the slots, as shown in Figure 4. The standoffs should be
on the inside of the robot chassis. Use (3) #4-40 nuts to loosely attach them to the chassis.
Do not tighten yet.
Small robot chassis, upside-down, side views
Step 9. Plug the power cable into the Power Pack output jack and thread the cable through the hole to
the top side of the chassis.
Step 10. Carefully insert the Li-ion Power-Pack at a slight angle, into the chassis, as shown Figure 5 (a).
Insert the board so as not to crimp the servo cables. Use (3) #4-40 x ¼" pan head screws to
attach the Li-ion Power Pack to the standoffs (space will be tight; pliers or a magnetic
Copyright © Parallax Inc.
Figure 4 – Attach Standoffs
Li-ion Small Robot Power Pack-Charger (#28988)
Attach the (3) sets of
F/M Hex aluminum
standoffs to the chassis
using #4-40 nuts. The
standoffs should be on
the underside and the
nuts on the top.
Use #4-40 nuts to
attach (3)
standoffs to the
chassis.
v1.2 3/3/2015 Page 6 of 10
Advertisement
