Advertisement
QUADRA 8R2
INSTALLATION MANUAL
IMPORTANT
Read all instructions
carefully before starting
the installation.
Throughly inspect
your product before
proceeding with
installation.
The warranty will be void
if the product is installed
with a conspicuous
defect.
CAUTION
To prevent leaks, silicone
must be applied on the
outside of the shower
and not inside!
Save this manual for
future reference.
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for ACRITEC QUADRA 8R2
Summary of Contents for ACRITEC QUADRA 8R2
- Page 1 QUADRA 8R2 INSTALLATION MANUAL IMPORTANT Read all instructions carefully before starting the installation. Throughly inspect your product before proceeding with installation. The warranty will be void if the product is installed with a conspicuous defect. CAUTION To prevent leaks, silicone...
- Page 2 COMPONENTS AND BOX CONTENTS COMPONENTS AND BOX CONTENTS No. Description No. Description o. Description No . De scri ption Q ty 13 Wall fixing screw(4x30) Trim strip Wall fixing screw (4 x 30) Trim strip 14 Frame fixing screw(4x12) Wall profile Wall profile Frame fixing screw (4 x 12) 15 Handle complete inside &...
- Page 3 FIXING KIT COMPONENTS, TOOLS REQUIRED, SITE CONDITIONS Bottom 4 x 30mm 4 x 12mm 2.7 x 12mm x 16 x 16 x 16 x 16 2.5mm Tools required • 6mm Masonry drill bit • Power drill • Quality silicone • Pencil •...
- Page 4 INSTALL FIXED PANEL AND GUIDING RAIL Ensure the shower tray is level in all TRAY MUST BE 100% LEVEL IN ALL DIRECTIONS directions and is properly sealed to the wall. The wall must be tiled down to the top edge of the tray. Do not angle out the bottom tile.
- Page 5 FIXED FRAMEWORK IN S ID E IN S ID E IN S ID E Φ6 4x30 Step 4 (2) 3/4” from the outside edge of the tray. Ensure Step 5 Step 6 Drill holes with 6mm masonry drill bit and insert the wall plugs (12). Step 7 (13)
- Page 6 INSTALL MOVING PANEL Step 8 Place the assembled frame onto the tray and slot into the wall Step 9 Install the top and bottom double rollers (11) & (18) To the top/bottom holes of the moving panels. See X and Z. (Do not over tighten screw on bottom roller as shown in Z).
Need help?
Do you have a question about the QUADRA 8R2 and is the answer not in the manual?
Questions and answers