Advertisement
Updated: 2021/05/14
IMPORTANT
Thoroughly inspect your product before proceeding with the installation.
The warranty will be void if the product is installed with a conspicuous defect.
CAUTION
To prevent leaks, silicone must be applied on the outside of the shower and not on the inside!
Read all instructions carefully before starting the installation.
Save this manual for future reference.
Single Threshold Sliding Bypass Door
INSTALLATION MANUAL
B03 Series
Advertisement
Table of Contents
Related Manuals for ACRITEC B03 Series
Summary of Contents for ACRITEC B03 Series
- Page 1 B03 Series Single Threshold Sliding Bypass Door Updated: 2021/05/14 INSTALLATION MANUAL IMPORTANT Thoroughly inspect your product before proceeding with the installation. The warranty will be void if the product is installed with a conspicuous defect. CAUTION To prevent leaks, silicone must be applied on the outside of the shower and not on the inside! Read all instructions carefully before starting the installation.
-
Page 2: Parts List
PARTS LIST Name Name 10 Guide block Wall profile UR 11 Bottom track cover, right 2 Door panel Wall plug 12 Roller cover 4 Bumper block 13 Roller 5 Handle 14 M5*16grub screw 6 ST4*30 Screw 15 Top track cover 7 Bottom track cover 16 Top track 8 Bottom track... -
Page 3: Component List
COMPONENT LIST Roller Top track cover Bottom track cover Bottom track cover Bumper block Guide block left x1 right x1 Cover cap Roller cover Screw 2.5mm hex wrench Handle Screw Wall plug 4mm hex wrench M5*16 Grub screw TOOLS AND MATERIALS REQUIRED DRILL LEVEL SCREWS... -
Page 4: Installation Site
INSTALLATION SITE TRAY MUST BE 100% LEVEL IN ALL DIRECTIONS Ensure the shower tray is level in all direction and is properly sealed to the wall. The wall must be tiled down to the bottom edge of the tray. Do not angle up bottom tile. - Page 5 CONTINUED Put the top track on the wall and install the door panel: 1. Install the rollers to the door panel; 2. Hang the door panel on the inner groove of the top track; 3. Install the lower slide block on the bottom tracm; 4.
- Page 6 CONTINUED 1. lnstall handle. 2. lnstall grub screw to roller bracket, tigeten and install cover cap. 3. lnstall top/bottom track covers. 4. lnstall roller cap. Adjust gap between guide block and glass.
- Page 7 CONTINUED Apply silicone to inside and outside of the shower enclosure. Do not use the enclosure for 24 hours after sealing.
- Page 8 Acritec Industries Corp. 27049 Gloucester Way Langley, B.C. V4W 3Y3 Tel: 604.607.0856 Fax: 604.607.0857 Email: info@acritec.com Website: www.acritec.com...
Need help?
Do you have a question about the B03 Series and is the answer not in the manual?
Questions and answers