Sensio SA9007 Installation Instructions

Installation
Instructions
IMPORTANT: Please read these instructions before starting installation and retain for future reference.
Components:
Surface Light
Screws
Important Safety Information
Please read these instructions carefully before attempting to install this product.
It is advisable to k eep these instructions in a safe place for further reference. These products must not be modified; if
any modifications are made, it may invalidate the warranty and may render the product unsafe. These LED lights
operate on low voltage (24V ). Do not wire the individual LED light fixtures directly to line power. This product is for
indoor use only. K eep out of moisture and use only in dry rooms.
The National Electrical Code (NEC) does not permit cords to be concealed where damage to insulation may go
unnoticed. To prevent fire danger, do not run cord behind walls, ceilings, soffits, or cabinets where it may be
inaccessible for examination. Cords should be visually examined periodically and immediately replaced when any
damage is noted.
CAUTION - To reduce the risk of fire, electric shock , or injury to persons:
a) Use only insulated staples or plastic ties to secure cords
b) Route and secure cords so that they will not be pinched or damaged when the cabinet is pushed to the wall
c) Not intended for recessed installation in ceilings, or soffits.
Safety Instructions
1. Turn off the main electrical supply for the appropriate
circuit at the break er box.
2. This product is only suitable for connecting to a 24V DC
power source.
3. Position lights where they will not be exposed to
steam, splashes, etc.
4. The LEDs in this fixture cannot be replaced.
Square Surface
Mount Puck Light
(1.25W)
Product #: SA9007
Adhesive
pad
Installation
Instructions
Tools Required:
Drill
5. Suitable for under cabinet lighting, attached to a
mounting surface such as wood or laminate.
6. Failure to use surge protection in problem areas will
void the warranty.
7. Use only approved accessories.
8. IMPORTANT: Fixture must NOT be covered by
insulation.
Drill Bit
9-11mm
(3/8" -7/16" )
Screwdriver Bit