Sensio SA10372 Installation Instructions

Installation
Instructions
IMPORTANT: Please read these instructions before starting installation and retain for future reference.
Required Materials:
Flexible Strip
Driver
(Sold Separately)

Important Safety Information

Please read these instructions carefully before attempting to install this product.
It is advisable to k eep these instructions in a safe place for further reference. These products must not be modified; if
any modifications are made, it may invalidate the warranty and may render the product unsafe. These LED lights
operate on low voltage (24V ). Do not wire the individual LED light fixtures directly to line power. This product is for
indoor use only. K eep out of moisture and use only in dry rooms.
The National Electrical Code (NEC) does not permit cords to be concealed where damage to insulation may go
unnoticed. To prevent fire danger, do not run cord behind walls, ceilings, soffits, or cabinets where it may be
inaccessible for examination. Cords should be visually examined periodically and immediately replaced when any
damage is noted.
CAUTION - To reduce the risk of fire, electric shock , or injury to persons:
a) Use only insulated staples or plastic ties to secure cords
b) Route and secure cords so that they will not be pinched or damaged when the cabinet is pushed to the wall
c) Not intended for recessed installation in ceilings, or soffits.

Safety Instructions

1. Turn off the main electrical supply for the appropriate circuit
at the fuse board.
2. This product is only suitable for connecting to a 24V DC power
source.
3. Position lights where they will not be exposed to persistent
steam, splashes, etc.
4. The LEDs in this fixture cannot be replaced.
Flexible 16.4' (5 meter)
24W 300 Diode IP65
Strip Light
Product #: SA10372
Driver Lead
(Sold Separately)
Required Tools :
Drill
Pencil
Screwdrive
r Bit
5. Suitable for under cabinet lighting, attached to a mounting
surface such as wood or laminate.
6. Failure to use surge protection in problem areas will void the
warranty.
7. Use only approved accessories.
8. IMPORTANT: Fixture must NOT be covered by insulation.
Measuring
Tape
Drill
Bit
Staple Gun
(optional)
Scissors