Table of Contents
Advertisement
Communicate Using Ad Hoc Mode
Wireless Ad Hoc Connection
If Ad Hoc mode is used (connecting directly to another computer), the
wireless LAN devices can directly connect to each other without a wireless
LAN access point. Set the first computer to Ad hoc mode and then connect
the other computers to the first computer.
To create an Ad Hoc network
1
Select
Turn Radio On
area on the lower right desktop screen.
The wireless LAN turns on and the WLAN (wireless LAN) lamp turns green.
Or, If the icon is not displayed in the communication area, click Windows
Start, point to
Marvell Wireless Soft_g_SoftAP Configuration
•
From the Operation Mode screen, select
Radio Off check box is unchecked. Proceed to Step 4.
2
Select
Select Mode
area on the lower right desktop screen. The Select Operation Mode screen
displays.
3
Select
Station
4
Click Windows
displays.
5
Click the
6
Click the
displays.
7
Right click the
The Wireless Network Connection Properties screen displays.
8
Click the
9
Click Advanced. The Advanced screen displays.
10
Select
Only computer-to-computer (ad hoc) networks
Access and click Close.
This allows you to connect only to Ad Hoc networks.
11
Click Add. The Wireless Network Properties screen displays.
73
by right-clicking the red icon in the taskbar notification
All Programs > Marvell Wireless SoftAP
by right clicking the red icon in the taskbar notification
in the Select Operation Mode screen and click OK.
Start
and then click
Network and Internet Connections
Network Connections
Wireless Network Connections
Wireless Networks
Station Mode
Control
Panel. The Control Panel screen
icon.
icon. The Network Connections screen
icon and click on Properties.
tab.
VGX-XL1 Living Room Entertainment Computer
and then click
Utility.
and make sure the
in Network to
Advertisement
Chapters
Table of Contents
