Advertisement
Before arranging any connection, be sure to unplug the device
from power source. All connections must be made with the
fixture off.
1.
Please be sure that the batteries in the transmitter are fully charged and if
necessary replace them. If you have a handy microphone unscrew the lower
part (10) to open the battery compartment, where you can put 2 AA batteries
(not included). The same batteries can be inserted in the headset version, by
opening the front cover (14). Be careful to respect the indicated polarities and
remove the batteries from the devices if you won't use it for a long time.
2.
If you need to connect the receiver to a mixer or an amplifier, use the socket
(5 or 7) and a cable with jack 6,3 mono connector.
3.
Connect the included adaptor to the back socket(6) and then to the 230V
mains.
4.
After turning on the other fixtures of your audio system, press the on/off button
(4) on the base.
5.
If you own the handy version, press the on/off button (9). The led (8) will light
on for a while to confirm correct operation. Warning: the switch (9) has 3 posi-
tions: OFF, MUTE and ON. Be sure that it makes two steps and it is posi-
tioned on "ON".
6.
If you own a bodypack transmitter, connect the microphone(15) to the socket
(11). Press the on/off button (12). The led (13) will light on for a while to
confirm correct operation. Warning: the switch (12) has 3 positions: OFF,
MUTE and ON. Be sure that it makes two steps and it is positioned on "ON".
The transmitter can be fastened to your belt thanks to the clip, allowing you
to operate handfree. The headset can be worn behind the neck so that the
microphone will be in front of your mouth.
7.
The receiving base is endowed with a practical display (2) showing main infor-
mation such as operating frequency, signal level etc....
8.
The RF led (3) flashes to indicate that the voice is perceived by the receiving
base.
Ulteriori informazioni su: www.karmaitaliana.it
9
Advertisement
