Nidac Presco PEL1 Installation Manual

PEL1
Presco™ Event Logger
"Series 1"
INSTALLATION MANUAL
INTRODUCTION
The Presco™ Event Logger makes programming multiple
Presco™ PAC1 and PAC2 door access controllers a
breeze, providing a user friendly platform for access control
with full upload/download capabilities directly from your PC.
Maximum security is provided with 3 different operator
levels for programming, editing user details or simply
viewing events. When an event is logged it is locked into
memory and cannot be manipulated, so you know the
integrity of your access control system is assured.
FEATURES
 Compatible with PAC1 & PAC2 controllers from series 1
to series 3.
 Holds 800 users with names up to 32 characters long.
 Monitors and programs up to 8 PAC controllers allowing
control of up to 16 doors when using PAC2s.
Stores 5,000 events with time and date stamping.

Simple USB connection to PC.

PC software included for Windows Vista, 7 and 8.1.

 Three software operator levels restricts access to
programming features.
 Replaceable button cell battery holds event memory and
keeps internal clock running for up to 10 years.
36 month (3 year) manufacturer's warranty.

 Designed and manufactured in Australia.
SPECIFICATIONS
Voltage:
1
(absolute min-max)
Current:
PC Interface:
Max USB cable length:
Max wiring distance from
PEL1 to PAC:
Operating Temperature:
Size:
Weight:
1 Operating the unit at a voltage outside the specified range may cause
intermittent operation or result in damage to the unit.
TERMINAL DESCRIPTIONS
GND Negative input (or ground) from the power supply.
+12V 12 Volt D.C. positive input from the power supply.
DLOG1 DLOG connection to the first PAC controller.
DLOG2 DLOG connection to the second PAC controller.
DLOG3 DLOG connection to the third PAC controller.
DLOG4 DLOG connection to the fourth PAC controller.
DLOG5 DLOG connection to the fifth PAC controller.
DLOG6 DLOG connection to the sixth PAC controller.
DLOG7 DLOG connection to the seventh PAC controller.
DLOG8 DLOG connection to the eighth PAC controller.
INSTALLATION
Read all instructions carefully before installing and using the
system. It is vital that power be disconnected during wiring.
The PEL1 is to be installed indoors and in a dry secure place.
There are 3 indicator LEDs on the PEL as shown below.
The Power LED indicates that the PEL has power and is
working. The first time it is powered up this led will flash
until the memory and clock have been initialised. If this
LED continues to flash it indicates an internal memory error
and the unit should be returned to the supplier.
The PAC Event Activity LED flashes each time the PEL1
receives an event on a DLOG line from any connected PAC.
The USB connected LED will be on whilst the PEL1 is
communicating with the PC software.
Hold down the Reset Button for 10 seconds to do a full
memory reset, except for the clock. The Power LED will
flash after 10 seconds to indicate that a reset will be
performed when the button is released. If the button is held
down for over 15 seconds it will cancel the reset and the
Power LED will stop flashing.
10-15 Volts D.C.
80 mA D.C.
USB 2.0 Mini B
5m
1km using 14/0.20. Units may
need to be powered separately.
0C to 50C.
104mm x 72mm x 27mm.
150g.