Table of Contents
Advertisement
Safety
3.2.7 Coupling and uncoupling attachments
•
Only connect and disconnect attachments when the engine is off and the PTO is off.
•
When changing attachments and their parts, use suitable tools and
•
Wear gloves.
•
When mounting and dismounting, bring the required support equipment into the respective
position and ensure sufficient stability.
•
Secure the self-propelled work machine and the attachment against rolling away (parking brake,
wheel chocks).
•
When attaching attachments, there is a risk of injury (crushing). Special care is necessary.
•
Attach implements according to regulations and fix in the prescribed places.
3.2.8 Maintenance, cleaning and repair work
•
Only carry out maintenance and cleaning work with the drive switched off and the motor
stationary!
•
If guards and working tools are subject to wear, they must be checked regularly and
replaced if necessary.
•
Only use original spare parts from the manufacturer, as these comply with the technical
requirements and thus the risk of accidents is minimized!
•
Cleaning with the high-pressure cleaner should be carried out so that the water jet is not held
directly in bearings, turned parts, grease nipples, shaft seals, wheel hubs, etc. After each
cleaning with the high-pressure cleaner, the lubrication points must be re-greased. In the
case of infringement, the right to guarantee expires!
•
Check the moving parts for ease of movement and degrease if necessary!
•
After maintenance and cleaning work, be sure to replace the guards and put them in the
protective position!
•
To avoid the risk of fire, keep the machine clean!
•
Regularly check nuts and bolts for tightness and retighten if necessary.
•
When carrying out maintenance, cleaning and repair work on the lifted device always make
sure that it is protected by suitable support elements!
•
Before carrying out any repairs, make sure that the hydraulic system is depressurized,
because fluids under pressure can penetrate the skin and cause serious injuries! Therefore
immediately see a doctor - risk of infection!
•
Repairs may only be carried out by qualified personnel.
•
Check the hydraulic hose lines for damage and aging at regular intervals and replace if
necessary.
•
When welding the tractor or mounted equipment, disconnect the battery.
•
Repairs such as welding, grinding, drilling, etc. must not be carried out on structural and
other safety-related parts such as frames, axles, etc.!
8
Advertisement
Table of Contents
