Haier DW-86L579BP Operation Manual page 18

4.Setting the low temperature alarm
•In unlocked mode, press "Set" key to select "Low Temp. Alarm", the temperature display fl ashes
and displays the setting value.
•Then, press " " or " " key, adjust the low temperature alarm setting value.
Temperature seeting range: lowest at -91℃ , and 5℃ or higher than the inner temperature setting.
•After adjusting, do not touch the unit for 10 seconds. The unit automatically enters the locked
mode and the temperature display stops fl ashing which means the value set have been input into
the computer. Otherwise, the setting is invalid.
For example: Set the low temperature alarm to -91℃ .
5.User parameters
•Parameters: dA, T1, T2, P6, IC, PS1, CL1.
•Entry mode: After the display board unlocks and the unlocking indicator lamp is OFF, Press and
hold the " " to 5s and enter into user parameters;
•Press the " " or " " key to select dA, T1, T2, P6, IC , PS1 and CL1 after accessing to the
user parameters;
select one of these parameters and then press the "Set" key to modify this parameter.
6.Regulation mode and scope of parameter value
•dA: 5 min is the default value for the delayed door open alarm. It is adjustable from 1min to 30min;
Press the " " or " " key to modify the set value of delayed door open alarm;
•Tl: 6 min is the default value for the USB data reading cycle. It is adjustable from 1min to 99min;
Press the " " or " " key to modify the set value of USB data reading cycle;
•T2: USB timing, MM(P2:01~12 ) /DD(P3 : 01~31)/ YYYY(Pl:10~99 )/Hour(P4 : 00-23 )/Minute(P5 :
00-59);
Press the " " or " " key to modify the timing of USB;
•P6: 12 is the default value for USB derivative mode; it is adjustable from 0 to 12;
The data can be exported in diff erent time frames with parameters of 0~12, among which, 12, as
default, means exporting the data generated from 1 year by one time; 0 means exporting all data
by one time; 1-12 means exporting the data generated from previous months, such as 2 months, 3
months...12 months.
Press the" " key or " " key to modify the USB derivative;
•IC: 008 is the default register password of IC card; it is adjustable from 000 to 999;
Press the " " key or " " key to modify the register password of IC card.
•PS1: 06 is the default value for the unlocking password; it is adjustable from 01 to 99;
Press the " " key or " " key to modify the unlocking password;
Setting method:Press the " " key or "
the " " key or " " key to get +1/-1 every 1s ; it will increase or decrease 10 every 1s when
continuous addition or decrease of 10 takes place.
" key to get +1/-1 for the password; Press and hold
16
•Notebook
It can be used to create new message, and view the records. For previous records, you can
directly click them for modifi cation and saving in the pop-up interface; when clicking [Delete], you
can delete one or all messages.
33