https://appliancetechmanuals.com
Brake Test
•
Tub should stop spinning 7 seconds after lid is lifted.
•
If the tub takes approximately 10 seconds to stop, check drive belt for wear.
•
If tub coasts to stop, brake resistor has failed and inverter/motor assembly must be replaced.
•
If the tub takes longer than 25 seconds to stop, the inverter will initiate a brake resistor error code. (See
Inverter/Motor Error Codes
The brake resistor is
permanently molded
into the underside of
the inverter cover.
.
)
– 40 –